When you are planning to get the Cisco Cisco certification but never know the best way to prepare pertaining to it, Examcollection may offer you an absolute ideal and fast way. We have a mass involving Cisco 300-075 exam brain dumps. With our Cisco 300-075 education course, you are going to get every one of the 300-075 important contents. Examcollections Cisco 300-075 exam questions and answers are gathered by thousands involving successful certified professionals around the globe. You will get a full spectrum in the Cisco 300-075 actual analyze. Master all the important topics of the Cisco preparation supplies, you are ensured to pass the real exam.

2021 Mar 300-075 latest exam

Q41. Refer to the exhibit. 

When a user presses a speed dial to +442079460255 when the SAF network is down, which event should occur? 

A. The call will reroute via the PSTN with the constructed PSTN number as 442079460255. 

B. The call will reroute via the PSTN with the constructed PSTN number as +442079460255. 

C. The call will reroute via the PSTN with the constructed PSTN number as 00442079460255. 

D. The call will fail because the ToDID is 0:. 

E. The call will fail because the called number will be 2079460255. 

Answer: B 


Q42. Which two actions are performed by the Call Control Discovery service after the local Cisco Unified Communications Manager loses its TCP connection with the primary and secondary Service Advertisement Framework? (Choose two.) 

A. Calls are routed to the PSTN gateway after the Call Control Discovery Learned Pattern IP Reachable Duration parameter expires. 

B. All learned patterns are purged from the local cache after the Call Control Discovery PSTN Failover Duration parameter expires. 

C. The Service Advertisement Framework forwarder contacts all the remaining Service Advertisement Framework forwarders in the cluster. 

D. All the remaining Service Advertisement Framework forwarders are notified for their learned patterns. 

E. The Cisco Unified Communications Manager establishes a connection with the primary and secondary Service Advertisement Framework after the Learned Pattern IP Reachable Duration parameter expires. 

F. Call Control Discovery immediately redirects all the calls to the PSTN gateway based on the learned patterns. 

Answer: A,B 


Q43. Which method can be used to address variable-length dial plans? 

A. Overlap sending and receiving. 

B. Add a prefix for all calls that are longer than 10-digits long 

C. Use nested translation patterns to eliminate inter-digit timeout 

D. Use the @macro on the route pattern 

E. Use MGCP gateways, which support variable-length dial plans 

Answer: A 

Explanation: 

Incorrect Answer: B, C, D, E If the dial plan contains overlapping patterns, Cisco Unified Communications Manager does not route the call until the interdigit timer expires (even if it is possible to dial a sequence of digits to choose a current match). Check this check box to interrupt interdigit timing when Cisco Unified Communications Manager must route a call immediately. By default, the Urgent Priority check box displays as checked. Unless your dial plan contains overlapping patterns or variable length patterns that contain!, Cisco recommends that you do not uncheck the check box. Link: 

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmfeat/fsintrcm.htm 


Q44. Refer to the exhibit. 

Which statement about the configuration between the Default and BR regions is true? 

A. Calls between the two regions can use either 64 kbps or 8 kbps. 

B. Calls between the two regions can use only the G.729 codec. 

C. Only 64 kbps will be used between the two regions because the link is "lossy". 

D. Both codecs can be used depending on the loss statistics of the link. When lossy conditions are high, the G.711 codec will be used. 

Answer: B 


Q45. Refer to the exhibit. 

The HQ site uses area code 650. The BR1 site uses area code 408. The long distance national code for PSTN dialing is 1. To make a long distance national call, an HQ or BR1 user dials access code 9, followed by 1, and then the 10-digit number. Both sites use MGCP gateways. AAR must use globalized call routing using a single route pattern. Assume that all outgoing PSTN numbers are localized at the egress gateway as shown in the exhibit. Which statement is true? 

A. The AAR group system must be configured on the device configuration of the phones. 

B. The AAR group system must be configured on the line configuration of the phones. 

C. The single AAR group system cannot be used. A second AAR group must be configured in order to have source and destination AAR groups. 

D. The AAR group system must be configured under the AAR service parameters. 

Answer: B 


Avant-garde 300-075 actual test:

Q46. Company X has deployed a VCS Control with a local zone and a traversal client zone. To facilitate external calls, VCS Expressway is deployed and traversal server zone is set up there. Video endpoints inside Company X have registered but are unable to receive calls from outside endpoints. Which option could be the cause of this issue? 

A. The access control list on the VCS Control must be updated with the IP for the external users. 

B. When a traversal zone is set up on VCS Control only outbound calls are possible. 

C. The local zone on the VCS Control does not have a search rule configured. 

D. The traversal zone on the VCS Control does not have a search rule configured. 

Answer: C 


Q47. Which two statements are true regarding the implementation of globalized call-routing in terms of localized call egress? (Choose two.) 

A. Calling-party numbers are routed from the gateway or trunks to phones. 

B. Called-party numbers are routed from the gateway or trunks to phones. 

C. Calling-party numbers of internal calls are routed from the gateway or trunks. 

D. Calling-party calls are routed to the gateway and trunks. 

Answer: A,D 


Q48. The administrator at Company X is trying to set up Extension Mobility and has done these steps: 

-Set up end users accounts for the users who need to roam 

-Set up a device profile for the type of phones users will be allowed to log in Users have reported to the administrator that they are unable to log in to the phones 

designated for Extension Mobility. Which two options are the two reasons for this issue? (Choose two.) 

A. The user device profile is not associated to the correct end user. 

B. The username must be numeric only and must match the DN. 

C. The Extension Mobility service has not been enabled under the Cisco Unified Serviceability Page. 

D. Extension Mobility has not been enabled under Enterprise Parameters. 

E. The user must ensure that their main endpoint is online and registered, otherwise they cannot log in elsewhere. 

Answer: A,C 


Q49. Which two configurations are needed to implement SRST in Cisco Unified Communications Manager? (Choose two.) 

A. SRST Gateway setting in Cisco Unified Communications Manager 

B. SRST Reference configured in Cisco Unified Communications Manager 

C. Device Pool SRST Reference setting 

D. Call Manager Group setting 

E. Cisco Unified Communications Locations setting 

Answer: B,C 


Q50. Which option is known as the location attribute that the global dialplan replication uses to advertise its dial plan information? 

A. location controller 

B. route pattern 

C. route string 

D. URI 

Answer: C