Cisco 300-207 exam is a good Cisco certification exam which aims in order to test any candidate?¡¥s knowledge and also skills inside practical work. Should you be one of the IT aspirants but using no Cisco Cisco certification, Ucertify will be your excellent help. Ucertify.internet is a web site which offers with students all of the accurate and also reliable Cisco 300-207 practice components. Try each of our 300-207 exam dumps, and you will pass the actual real exam effortlessly and confidently.
2021 Nov cisco exam 300-207:
Q61. What action will the sensor take regarding IP addresses listed as known bad hosts in the Cisco SensorBase network?
A. Global correlation is configured in Audit mode fortesting the feature without actually denying any hosts.
B. Global correlation is configured in Aggressive mode, which has a very aggressive effect on deny actions.
C. It will not adjust risk rating values based on the known bad hosts list.
D. Reputation filtering is disabled.
Answer: D
Explanation:
This can be seen on the Globabl Correlation – Inspection/Reputation tab show below:
Q62. What is the default CX Management 0/0 IP address on a Cisco ASA 5512-X appliance?
A. 192.168.1.1
B. 192.168.1.2
C. 192.168.1.3
D. 192.168.1.4
E. 192.168.1.5
F. 192.168.8.8
Answer: F
Q63. Which Cisco Web Security Appliance design requires minimal change to endpoint devices?
A. Transparent Mode
B. Explicit Forward Mode
C. Promiscuous Mode
D. Inline Mode
Answer: A
Q64. Joe was asked to secure access to the Cisco Web Security Appliance to prevent unauthorized access. Which four steps should Joe implement to accomplish this goal? (Choose four.)
A. Implement IP access lists to limit access to the management IP address in the Cisco Web Security Appliance GUI.
B. Add the Cisco Web Security Appliance IP address to the local access list.
C. Enable HTTPS access via the GUI/CLI with redirection from HTTP.
D. Replace the Cisco self-signed certificate with a publicly signed certificate.
E. Put the Cisco WSA Management interface on a private management VLAN.
F. Change the netmask on the Cisco WSA Management interface to a 32-bit mask.
G. Create an MX record for the Cisco Web Security Appliance in DNS.
Answer: A,C,D,E
Q65. Which sensor deployment mode does Cisco recommend when interface capacity is limited and you need to increase sensor functionality?
A. inline interface pair mode
B. inline VLAN pair mode
C. inline VLAN group mode
D. VLAN group mode
Answer: C
Most recent cisco exam 300-207:
Q66. What can Cisco Prime Security Manager (PRSM) be used to achieve?
A. Configure and Monitor Cisco CX Application Visibility and Control, web filtering, access and decryption policies
B. Configure Cisco ASA connection limits
C. Configure TCP state bypass in Cisco ASA and IOS
D. Configure Cisco IPS signature and monitor signature alerts
E. Cisco Cloud Security on Cisco ASA
Answer: A
Q67. Which command verifies that the correct CWS license key information was entered on the Cisco ASA?
A. sh run scansafe server
B. sh run scansafe
C. sh run server
D. sh run server scansafe
Answer: B
Q68. Which two Cisco IPS events will generate an IP log? (Choose two.)
A. A signature had an event action that was configured with log packets.
B. A statically configured IP or IP network criterion was matched.
C. A dynamically configured IP address or IP network was matched.
D. An attack produced a response action.
Answer: A,B
Q69. If learning accept mode is set to "auto" and the knowledge base is loaded only when explicitly requested on the IPS, which statement about the knowledge base is true?
A. The knowledge base is set to load dynamically.
B. The knowledge base is set to "save only."
C. The knowledge base is set to "discarded."
D. The knowledge base is set to load statically.
Answer: B
Q70. Which method does Cisco recommend for collecting streams of data on a sensor that has been virtualized?
A. VACL capture
B. SPAN
C. the Wireshark utility
D. packet capture
Answer: D