Getting your Cisco Cisco certification is the fantasy of numerous IT aspirants. But passing the Cisco 300-207 exam isnt an easy task without having any valuable preparatory materials. The 1st step is to find a great abundant resource for the Cisco 300-207 exam preparation. Now Pass4sure comes to assist you. The 300-207 exam additionally names Cisco Cisco exam which can be a Cisco certification. And also Pass4sure provides you with all the Cisco certification exam products which include the Cisco 300-207 exam demos.

2021 Feb ucr 207-300:

Q1. Refer to the exhibit. 

What CLI command generated the output? 

A. smtproutes 

B. tophosts 

C. hoststatus 

D. workqueuestatus 

Answer: B 


Q2. Which Cisco ESA predefined sender group uses parameter-matching to reject senders? 

A. BLACKLIST 

B. WHITELIST 

C. SUSPECTLIST 

D. UNKNOWNLIST 

Answer: A 


Q3. Over the period of one day, several Atomic ARP engine alerts fired on the same IP address. You observe that each time an alert fired, requests on the IP address exceeded replies by the same number. Which configuration could cause this behavior? 

A. The reply-ratio parameter is enabled. 

B. MAC flip is enabled. 

C. The inspection condition is disabled. 

D. The IPS is misconfigured. 

Answer: A 


Q4. Which is the default IP address and admin port setting for https in the Cisco Web Security Appliance? 

A. http://192.168.42.42:8080 

B. http://192.168.42.42:80 

C. https://192.168.42.42:443 

D. https://192.168.42.42:8443 

Answer: D 


Q5. Which Cisco IPS CLI command shows the most fired signature? 

A. show statistics virtual-sensor 

B. show event alert 

C. show alert 

D. show version 

Answer: A 


Improve sitcs 300-207:

Q6. Which five system management and reporting protocols are supported by the Cisco Intrusion Prevention System? (Choose five.) 

A. SNMPv2c 

B. SNMPv1 

C. SNMPv2 

D. SNMPv3 

E. syslog 

F. SDEE 

G. SMTP 

Answer: A,B,C,F,G 


Q7. Which two conditions must you configure in an event action override to implement a risk rating of 70 or higher and terminate the connection on the IPS? (Choose two.) 

A. Configure the event action override to send a TCP reset. 

B. Set the risk rating range to 70 to 100. 

C. Configure the event action override to send a block-connection request. 

D. Set the risk rating range to 0 to 100. 

E. Configure the event action override to send a block-host request. 

Answer: A,B 


Q8. You ran the ssh generate-key command on the Cisco IPS and now administrators are unable to connect. Which action can be taken to correct the problem? 

A. Replace the old key with a new key on the client. 

B. Run the ssh host-key command. 

C. Add the administrator IP addresses to the trusted TLS host list on the IPS. 

D. Run the ssh authorized-keys command. 

Answer: A 


Q9. What are two benefits of using SPAN with promiscuous mode deployment? (Choose two.) 

A. SPAN does not introduce latency to network traffic. 

B. SPAN can perform granular scanning on captures of per-IP-address or per-port monitoring. 

C. Promiscuous Mode can silently block traffic flows on the IDS. 

D. SPAN can analyze network traffic from multiple points. 

Answer: A,D 


Q10. Which two commands are valid URL filtering commands? (Choose two.) 

A. url-server (DMZ) vendor smartfilter host 10.0.1.1 

B. url-server (DMZ) vendor url-filter host 10.0.1.1 

C. url-server (DMZ) vendor n2h2 host 10.0.1.1 

D. url-server (DMZ) vendor CISCO host 10.0.1.1 

E. url-server (DMZ) vendor web host 10.0.1.1 

Answer: A,C