Act now and download your Cisco 300-209 test today! Do not waste time for the worthless Cisco 300-209 tutorials. Download Updated Cisco Implementing Cisco Secure Mobility Solutions (SIMOS) exam with real questions and answers and begin to learn Cisco 300-209 with a classic professional.
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-209 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-209 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-209-exam-dumps.html
Q71. When a tunnel is initiated by the headquarter ASA, which one of the following Diffie-Hellman groups is selected by the headquarter ASA during CREATE_CHILD_SA exchange?
A. 1
B. 2
C. 5
D. 14
E. 19
Answer: C
Explanation:
Traffic initiated by the HQ ASA is assigned to the static outside crypto map, which shown below to use DH group 5.
Q72. Which of the following could be used to configure remote access VPN Host-scan and pre-login policies?
A. ASDM
B. Connection-profile CLI command
C. Host-scan CLI command under the VPN group policy
D. Pre-login-check CLI command
Answer: A
Q73. A network administrator is configuring AES encryption for the ISAKMP policy on an IOS router. Which two configurations are valid? (Choose two.)
A. crypto isakmp policy 10
encryption aes 254
B. crypto isakmp policy 10
encryption aes 192
C. crypto isakmp policy 10
encryption aes 256
D. crypto isakmp policy 10
encryption aes 196
E. crypto isakmp policy 10
encryption aes 199
F. crypto isakmp policy 10
encryption aes 64
Answer: B,C
Q74. What does NHRP stand for?
A. Next Hop Resolution Protocol
B. Next Hop Registration Protocol C. Next Hub Routing Protocol
D. Next Hop Routing Protocol
Answer: A
Q75. Scenario:
You are the senior network security administrator for your organization. Recently and junior engineer configured a site-to-site IPsec VPN connection between your headquarters Cisco ASA and a remote branch office.
You are now tasked with verifying the IKEvl IPsec installation to ensure it was properly configured according to designated parameters. Using the CLI on both the Cisco ASA and branch ISR, verify the IPsec configuration is properly configured between the two sites.
NOTE: the show running-config command cannot be used for this exercise.
Topology:
Which crypto map tag is being used on the Cisco ASA?
A. outside_cryptomap
B. VPN-to-ASA
C. L2L_Tunnel
D. outside_map1
Answer: D
Explanation:
This is seen from the “show crypto ipsec sa” command on the ASA.
Q76. What are three benefits of deploying a GET VPN? (Choose three.)
A. It provides highly scalable point-to-point topologies.
B. It allows replication of packets after encryption.
C. It is suited for enterprises running over a DMVPN network.
D. It preserves original source and destination IP address information.
E. It simplifies encryption management through use of group keying.
F. It supports non-IP protocols.
Answer: B,D,E
Q77. A spoke has two Internet connections for failover. How can you achieve optimum failover without affecting any other router in the DMVPN cloud?
A. Create another DMVPN cloud by configuring another tunnel interface that is sourced from the second ISP link.
B. Use another router at the spoke site, because two ISP connections on the same router for the same hub is not allowed.
C. Configure SLA tracking, and when the primary interface goes down, manually change the tunnel source of the tunnel interface.
D. Create another tunnel interface with same configuration except the tunnel source, and configure the if-state nhrp and backup interface commands on the primary tunnel interface.
Answer: C
Q78. In which situation would you enable the Smart Tunnel option with clientless SSL VPN?
A. when a user is using an outdated version of a web browser
B. when an application is failing in the rewrite process
C. when IPsec should be used over SSL VPN
D. when a user has a nonsupported Java version installed
E. when cookies are disabled
Answer: B
Q79. Refer to the exhibit.
Which exchange does this debug output represent?
A. IKE Phase 1
B. IKE Phase 2
C. symmetric key exchange
D. certificate exchange
Answer: A
Q80. Where do you configure AnyConnect certificate-based authentication in ASDM?
A. group policies
B. AnyConnect Connection Profile
C. AnyConnect Client Profile
D. Advanced Network (Client) Access
Answer: B