Printable of 300-365 practice test materials and cram for Cisco certification for IT specialist, Real Success Guaranteed with Updated 300-365 pdf dumps vce Materials. 100% PASS Deploying Cisco Wireless Enterprise Networks exam Today!
♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 300-365 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 300-365 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/300-365-exam-dumps.html
2021 Apr 300-365 exam
Q1. Scenario
There is a problem with the East-WLC-2504A. When configuration changes are made to the Employees-East-Wing AP Group that covers the East-Wing, none of the APs receive the updates. Referto the exhibits to determine where the problems are.
What needs to be changed in the configuration of the East-WLC-2504A controller to restore functionality to the Employees-East-Wing AP Group? (Choose four.)
A. Change the AP in the Employees-East-Wing AP Group.
B. Change the IP Address in the east-wing interface.
C. Change the VLAN Identifier in the east-wing interface.
D. Enable Dynamic AP Management in the east-wing interface.
E. Change the Port Number to 2 in the east-wing interface.
F. Add the Primary Controller and IP address to the 3700-East-Wing AP.
G. Change the SSID in the Employees-East-Wing AP Group.
H. Change the Interface/Interface Group In the Employees-East-Wing AP Group.
Answer: D,F,G,H
Q2. A network engineer has installed 802.11ac access points with 80 MHz enabled; however, in the conference rooms, co-channel interference is being noticed. Under which tab in the RF profiles configuration can the engineer find the settings to tune the channel width for a group of APs?
A. 802.11
B. RRM
C. High Density
D. General
Answer: B
Q3. On which AP radio or radios is Cisco WGB association supported?
A. 2.4 GHz only
B. 2.4 or 5 GHz only
C. 2.4, 5, or 4.9 GHz
D. 5 GHz only
Answer: B
Q4. A customer has implemented several WLANs in an auditorium utilizing a newly dedicated WLC and is experiencing excessive channel utilization regardless of occupancy. Which action reduces channel utilization without removing SSIDs?
A. Disable MCS data rates 0 through 11.
B. Disable MCS data rates used by 40 MHz channels.
C. Disable data rates that use CCK.
D. Disable VHT data rates.
Answer: C
Q5. What are two functions of the RAP in a mesh network? (Choose two.)
A. It provides a wired connection for the wireless mesh APs.
B. It adds capacity and resilience to a mesh area.
C. it creates a centralized management location for the mesh network.
D. it reduces the hop count to the wireless network that is connected to the edge.
E. it routes traffic from the wireless mesh to the wired network.
Answer: B,D
Improved 300-365 free download:
Q6. Which statement about when you configure FlexConnect APs and you want to set up Cisco Centralized Key Management fast roaming is true?
A. FlexConnect groups are required for Cisco Centralized Key Management fast roaming to work with FlexConnect access points.
B. APs that are in the same FlexConnect group but associated to different WLCs support Cisco Centralized Key Management.
C. Cisco Centralized Key Management fast roaming among FlexConnect and non-FlexConnect access points is supported.
D. The FlexConnect access point must be in standalone mode to support Cisco Centralized Key Management.
Answer: A
Q7. After a wireless deployment, users report that wireless voice clients are experiencing an unacceptable amount of delay while roaming during a call on the Cisco Unified 7925 Series phones. The customer environment consists of multiple controllers, all running 7.4.121.0 code, operating in a centralized deployment. What configuration issue is most likely contributing to the problem?
A. The authentication should be set to WPA2-PSK to allow for 802.11n speeds for the Cisco Unified 7925 phones.
B. The access points on that floor are all on one controller and should be load balanced evenly across multiple controllers.
C. The access points for that floor are salt and peppered across multiple controllers and should be moved to the primary controller.
D. The wireless phones are operating in the 2 4 GHz band and should be configured for the 5 GHz band.
Answer: B
Q8. What is the default NMSP echo interval between a Mobility Services Engine and Wireless LAN Controller?
A. 30Seconds
B. 15 Seconds
C. 10 Seconds
D. 60 Seconds
Answer: B
Q9. An engineer wants to configure WebEx to adjust the precedence and override the QoS profile on the WLAN. Which configuration is needed to complete this task?
A. Change the AVC application WebEx-app-sharing to mark
B. Create an ACL for WebEx.
C. Change the WLAN reserved bandwidth for WebEx.
D. Create an AVC profile for WebEx marked with a lower DSCP value
Answer: A
Q10. A downstream packet containing a DSCP value arrives at the WLC Ethernet interface from the wired source network. The WLC is configured for QoS WLAN 802.1p mapping. How does the WLC treat the CAPWAP QoS marking when leaving the controller interface for the respective AP and final wireless client destination?
A. No outer CAPWAP or inner QoS tagging is applied.
B. No outer CAPWAP QoS tag is applied, but the original DSCP is maintained inside CAPWAP.
C. The outer CAPWAP CoS is marked and capped while the inner DSCP maintains the original marking.
D. The outer CAPWAP DHCP is marked and capped without any inner DSCP value.
Answer: C