♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 400-101 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 400-101 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/400-101-exam-dumps.html
Q411. Refer to the exhibit.
Which two commands are required on R3 in order for MPLS to function? (Choose two.)
A. mpls ip
B. ip cef
C. mpls label protocol tdp
D. mpls ip propagate-ttl
Answer: A,B
Q412. What are three benefits of deploying NAT with ALG? (Choose three.)
A. the use of dynamic ephemeral ports through a firewall
B. the synchronization of translations between multiple streams of data
C. the use of deep packet inspection
D. the use of static ephemeral ports through a firewall
E. the conversion of session layer addresses from the application payload to outside global addresses
F. NAT traversal to support asymmetric data sessions
Answer: A,B,C
Q413. Refer to the exhibit.
Which statement about this GET VPN configuration is true?
A. Router 1 acts as the primary key server because it has a higher priority.
B. An RSA key has been imported into the configuration.
C. The GDOI group configuration generated a key.
D. DPD is disabled.
Answer: A
Q414. Which statement about the feasible distance in EIGRP is true?
A. It is the maximum metric that should feasibly be considered for installation in the RIB.
B. It is the minimum metric to reach the destination as stored in the topology table.
C. It is the metric that is supplied by the best next hop toward the destination.
D. It is the maximum metric possible based on the maximum hop count that is allowed.
Answer: B
Explanation:
An EIGRP router advertises each destination it can reach as a route with an attached metric. This metric is called the route's reported distance (the term advertised distance has also been used in older documentation). A successor route for any given destination is chosen as having the lowest computed feasible distance; that is, the lowest sum of reported distance plus the cost to get to the advertising router. By default, an EIGRP router will store only the route with the best (lowest) feasible distance in the routing table (or, multiple routes with equivalent feasible distances).
Reference: http://packetlife.net/blog/2010/aug/9/eigrp-feasible-successor-routes/
Q415. What is the destination multicast MAC address for BPDUs on the native VLAN, for a switch that is running 802.1D?
A. 0185. C400. 0000
B. 0100.0CCC.CCCC
C. 0100.0CCC.CCCD
D. 0180.C200.0000
Answer: D
Explanation:
If the native vlan is 1:
A STP BPDU for VLAN 1 will be sent untagged to MAC 0180.c200.0000 (this is the
common spanning tree)
A PVST+ BPDU for VLAN 1 will be sent untagged to MAC 0100.0ccc.cccd
A PVST+ BPDU for all other vlans will be sent with a 802.1Q tag to MAC 0100.0ccc.cccd
(with a PVID = to the VLAN)
If the native vlan is not 1:
A STP BPDU for VLAN 1 will be sent untagged (on the native vlan) to MAC
0180.c200.0000 (this is the common spanning tree)
A PVST+ BPDU for VLAN1 will be sent with a 802.1Q tag to MAC 0100.0ccc.cccd (with a PVID=1)
A PVST+ BPDU for the native vlan will be sent untagged to MAC 0100.0ccc.cccd (with a PVID=native vlan)
A PVST+ BPDU for all other vlans will be sent with a 802.1Q tag to MAC 0100.0ccc.cccd (with a PVID = to the VLAN)
Q416. Which three types of traffic are protected when you implement IPsec within an IPv6-in-IPv4 tunnel? (Choose three.)
A. IPv6 link-local traffic
B. IPv6 multicast traffic
C. IPv6 unicast traffic
D. IPv4 tunnel control traffic
E. IPv4 broadcast traffic
F. IPv6 broadcast traffic
Answer: A,B,C
Q417. DRAG DROP
Drag and drop the Cisco IOX XE subpackage on the left to the function it performs on the right.
Answer:
Q418. Refer to the exhibit.
Which action must you take to enable full reachability from router C to router D?
A. Build an OSPF virtual link.
B. Build an OSPF sham link.
C. Configure mutual redistribution between OSPF and EIGRP on routers A and B.
D. Add a static route on router D.
Answer: C
Explanation:
For full connectivity, we need to configure mutual redistribution to advertise the EIGRP routes into OSPF and to advertise the OSPF routes into the EIGRP network. This needs to be done at the two border routers that connect to both the EIGRP and OSPF domains.
Q419. What are the three modes of Unicast Reverse Path Forwarding?
A. strict mode, loose mode, and VRF mode
B. strict mode, loose mode, and broadcast mode
C. strict mode, broadcast mode, and VRF mode
D. broadcast mode, loose mode, and VRF mode
Answer: A
Q420. DRAG DROP
Drag and drop the Cisco IOS XE subpackage on the left to the function it performs on the right.
Answer: