Regenerate 500-901 Exam Dumps For Cisco Data Center Unified Computing Infrastructure Design Certification

NEW QUESTION 1
An administrator is setting up a new VSAN and needs to use IVR to allow access to backup tape storage targets located in a different VSAN. There is an existing Nexus 5K switch in the SAN fabric that the admin would like to use; however, the switch is not IVR-enabled. How can the Cisco Nexus switch be used?

• A. It cannot be used, since only MDS Switches implement IVR.
• B. As a Transit switch.
• C. As a Border switch or IVR NAT gateway.
• D. As an Edge switch.

Answer: D

NEW QUESTION 2
Your System BIOS has ‘Hyper Threading’ enabled. However, you just created a BIOS Policy that has ‘Hyper Threading’ disabled. You attached this BIOS Policy to a Service Profile and associated this Service Profile to the existing Server. What action will occur next?

• A. The System BIOS takes precedence over the ‘BIOS Policy’, so ‘Hyper Threading’ will remain enabled
• B. The ‘BIOS Policy’ takes precedence over the System BIOS, so ‘Hyper Threading’ will be disabled
• C. The UCS Server will fail due to a mismatch configuration
• D. Some BIOS settings cannot be changed in UCS Servers, ‘Hyper Threading’ is one of them

Answer: B

NEW QUESTION 3
How many QoS classes are available to administrators on Cisco’s UCS server?

• A. 6
• B. 4
• C. 2
• D. 8

Answer: A

NEW QUESTION 4
What is contained in Service Profiles?

• A. Management and server configurations
• B. Identity and state information for a logical server
• C. Application specific service requirements
• D. State information for a physical server

Answer: B

NEW QUESTION 5
What are the RAID levels available in the mode drop-down list of the Local Storage Policy?

• A. RAID 0, 1, 5, 10
• B. RAID 0, 1, 3, 5
• C. RAID 0, 1, 5, 6, 50, 60
• D. RAID 0, 1, 5, 6, 10
• E. RAID 0, 1, 5, 10. 50

Answer: C

NEW QUESTION 6
You are creating a Local Disk Configuration Policy to be used by a new Service Profile for your UCS Server. Previous Service Profile had a Local Disk Configuration Policy set up for ‘No RAID’ and the ‘Protect Configuration’ box was checked. This time, you choose ‘RAID 1’ and deselect the ‘Protect Configuration’ checkbox. What are the implications of this change?

• A. The Service Profile association process will fail because you cannot change from ‘No RAID’ to ‘RAID 1’
• B. The Service Profile association process will fail because the policies are different and the ‘protect configuration’ option was checked
• C. The Service Profile association process will succeed, but your total disk capacity will be cut in half due to the change from RAID 0 to RAID 1
• D. The Service Profile association process will succeed, but it will adopt the previous Local Disk Configuration Policy instead of the new one because it had ‘protect configuration’ checked

Answer: B

NEW QUESTION 7
An application is running in a data center as a set of virtual machines running on a single physical host. The host is using an NPIV enabled HBA. What capability does this offer?

• A. Only the physical host can logically connect to the SAN fabric, thus enhancing security.
• B. The number of FlOGls is kept at a reasonable level, and therefore cannot saturate the SAN fabric.
• C. Inter VSAN traffic can be switched directly by the HBA.
• D. Each VM initiator can be managed independently, since it will generate its own FLOGl, and have its own pWWN.

Answer: D

NEW QUESTION 8
Which option is available for virtual switching in a VMware virtual environment?

• A. KVM virtual switch, distributed virtual switch, Cisco Nexus 100v
• B. Advanced virtual switch, distributed virtual switch, Cisco Nexus 100v
• C. Hypervisor virtual switch, distributed virtual switch, Cisco Nexus 100v
• D. Standard virtual switch, distributed virtual switch, Cisco Nexus 100v

Answer: D

NEW QUESTION 9
You just installed a group of new Cisco UCS Servers in an ESX Cluster. Now, you want to deploy Nexus 1000v in this virtual environment. Which two statements regarding the scenario are true? (Choose two.)

• A. Nexus 1000v VEM will act as the Control Plane, while Nexus 1000v VSM acts as a remote line card
• B. Nexus 1000v VSM will act as the Control Plane, while Nexus 1000v VEM acts as a remote line card
• C. Nexus 1000v is not supported on ESX
• D. Nexus 1000v VSM is deployed in vCenter, Nexus 1000v VEM is deployed in each ESX Host
• E. Nexus 1000v VEM is deployed in vCenter, Nexus 1000v VSM is deployed in each ESX Host

Answer: BD

NEW QUESTION 10
Which additional three traffic egress controls may be enabled in Cisco UCS Manager depending upon the network adapter selected? (Choose three.)

• A. Rate
• B. Best Effort
• C. Host Control
• D. Peak
• E. Burst
• F. Smooth

Answer: BCE

NEW QUESTION 11
An administrator has configured an NPV traffic map for a new server interface, none of the uplinks in the traffic map are open action?

• A. The traffic map will be disregarded and an uplink in the interface VSAN will be selected.
• B. The default VSAN uplink will be used if operational.
• C. The server will remain in a nonoperational state.
• D. The server interface will signal an FDISC message to the fabric switch.

Answer: C

NEW QUESTION 12
An administrator needs to configure NPV between an edge fabric switch which will support application servers, and an upstream core switch. A Fiber Channel (FC) link exist between the two switchers. What two statements are true about roles on the edge fabric switch? (Choose two.)

• A. The port that connects to the core switch will be an NP port.
• B. The ports that connect to the servers will be F ports.
• C. The port that connects the switches is a TE port.
• D. The port that connects to the core switch will be an FP port
• E. The ports that connect to the servers will be N ports.

Answer: AB

NEW QUESTION 13
......