The Most Up-to-date Guide To Jn0-361 Test Preparation

NEW QUESTION 1
Click the exhibit.

You are asked to enable a new BGP connection on R1, which has an existing IPv4 peering with R2. The new peering with R3 will use IPv6.
Referring to the exhibit, which two steps are required to enable the new IPv6 peering? (Choose two.)

• A. Configure an IPv6 address on the appropriate interface.
• B. Configure the rib inet6.0 statement under the BGP group.
• C. Configure an IPv6 neighbor address under the BGP group.
• D. Configure an IPv6 local address under the BGP group.

Answer: AC

NEW QUESTION 2
Which statement correctly describes a characteristic of IPv6 unicast addressing?

• A. Global addresses are in the range of 2002::/16.
• B. Only one loopback address exists, ::1/128.
• C. Link-local addresses are in the range of FF00::/8.
• D. Link-local addresses are in the range of FE00::/12.

Answer: B

NEW QUESTION 3
Click the Exhibit.

Referring to the exhibit, which IS-IS router will be selected as the DIS?

• A. Router 1
• B. Router 4
• C. Router 2
• D. Router 3

Answer: B

NEW QUESTION 4
Click the Exhibit.

Referring to the configuration shown in the exhibit, which statement is true?

• A. Traffic destined to address 192.168.5.1 will take next-hop 172.16.1.2.
• B. Traffic destined to address 192.168.5.1 will alternate between next-hops 172.16.1.2 and 172.16.1.3
• C. Traffic destined to address 192.168.5.1 will take next-hop 10.0.1.1.
• D. Traffic destined to address 192.168.5.1 will take next-hop 172.16.1.3.

Answer: D

NEW QUESTION 5
Click the exhibit.

A customer has two VLANs to extend between Site-1 and Site-2. The customer does not want to route the VLANs or renumber the VLANs.
Referring to the exhibit, which two VLAN IDs are egressing the MX Series device towards the optical transport network after translation? (Choose two.)

• A. 500
• B. 501
• C. 201
• D. 200

Answer: AB

NEW QUESTION 6
Click the Exhibit.

Referring to the exhibit, which two statements are true? (Choose two.)

• A. The LSP is protected with link protection.
• B. The last node in the path will not pop the MPLS label.
• C. The last node in the path will pop the MPLS label.
• D. The LSP is protected with fast reroute.

Answer: AC

NEW QUESTION 7
Click the Exhibit.

Referring to the configuration in the exhibit, which statement is true?

• A. The next-hop 172.16.1.2 must be directly connected to the router for route 192.168.5.0/24 to be active.
• B. The next-hop 172.16.1.2 must be part of an active route in route table inet.0 for route 192.168.5.0/24 to be active.
• C. The next-hop 172.16.1.2 must respond to ping commands for the route 192.168.5.0/24 to be active.
• D. The next-hop 172.16.1.2 must be active in route table inet.3 for the route 192.168.5.0/24 to be active.

Answer: B

NEW QUESTION 8
Click the Exhibit.


You are using OSPF as your IGP in your network. You have applied the OSPF configuration shown in the exhibit to router R1.
Which statement is true in this scenario?

• A. Router R1 must be configured as a stub area for Area 0.0.0.0.
• B. Router R1 will send a default route to router R2.
• C. Router R2 will not have a route to subnet 172.16.4.0/24.
• D. Router R3 will not have a route to subnet 172.16.3.0/24.

Answer: D

NEW QUESTION 9
Click the exhibit.

In the exhibit, which two routers will perform a swap action on LSP1? (Choose two.)

• A. R1
• B. R2
• C. R4
• D. R3

Answer: AB

NEW QUESTION 10
Click the Exhibit. Route
Next-hop AS-Path Origin
Local Preference Route 1
ISP 1
123 88 65512
I 100
Route 2
ISP 2
678 651111
E 100
Route 3
ISP 3
3245 6532 1231 65510
? 200
Route 4
ISP 4
65512
E 150
You are receiving the same route prefix from four EBGP neighbors.
Based on the information provided in the exhibit, which route will be selected?

• A. Route 4
• B. Route 1
• C. Route 2
• D. Route 3

Answer: C

NEW QUESTION 11
You are configuring a default static route using the default preference value. You want to ensure that any static route that you configure in the future will be less preferred than the OSPF routes that are configured on the network.
Which command will accomplish this task?

• A. set protocols ospf preference 6
• B. set routing-options static route <IP address> preference 9
• C. set routing-options static defaults preference 20
• D. set routing-options static defaults passive

Answer: C

NEW QUESTION 12
Click the Exhibit.


Referring to the exhibit, R-1 and R-2 are connected with a LAG on the ae0 interface. However, the LAG is not operational.
Which action will solve this problem?

• A. Change one device to use LACP passive mode.
• B. Change the system ID on one device.
• C. Set the LACP system priority to a non-zero value on one device.
• D. Set the LACP system priority to a non-zero value on both devices.

Answer: B

NEW QUESTION 13
An IS-IS TLV includes which two attributes? (Choose two.)

• A. Topology
• B. Vector
• C. Length
• D. Value

Answer: CD

NEW QUESTION 14
A customer pays for the bandwidth on a per-packet basis. The network administrator wants to constrain costs and prevent Layer 2 loops on a multihomed Layer 2 WAN network.
Which technology would satisfy these requirements?

• A. Rapid Spanning Tree Protocol
• B. Multiple Spanning Tree Protocol
• C. Loop protection
• D. MPLS over GRE

Answer: C

NEW QUESTION 15
Which two statements correctly describe the BGP community attribute? (Choose two.)

• A. Only one community can be associated with a route.
• B. The community attribute is an optional nontransitive attribute.
• C. Multiple communities can be associated with a route.
• D. The community attributes is an optional transitive attribute.

Answer: CD

NEW QUESTION 16
Click the Exhibit.

By default, at which router will the implicit null (Label3) action take place for LSP shown in the exhibit?

• A. R4
• B. R2
• C. R1
• D. R3

Answer: D

NEW QUESTION 17
Which two statements are true about NSR? (Choose two.)

• A. NSR requires graceful restart to function properly
• B. NSR requires redundant REs.
• C. NSR requires only one RE.
• D. NSR requires GRES to function properly.

Answer: BD

NEW QUESTION 18
Click the Exhibit.

You have just configured IS-IS, but the adjacency is not coming up. Referring to the exhibit, what is the cause?

• A. Only one side is configured using the point-to-point parameter.
• B. One router is configured for Level 2 only.
• C. The routers must be in different areas.
• D. The family iso parameters is missing on the interfaces.

Answer: A

NEW QUESTION 19
Click the Exhibit.

Your network consists of subnets shown in the exhibit. You are asked to create an aggregate route for Router 1.
What is the appropriate prefix for the aggregate route in this scenario?

• A. 172.42.32.0/20
• B. 172.42.32.0/22
• C. 172.42.32.0/19
• D. 172.42.32.0/21

Answer: C

NEW QUESTION 20
Click the Exhibit.



Referring to the exhibit, which route(s) will be exported to neighbor 192.168.1.2?

• A. 100.0.1/32 and 100.0.20.1/32
• B. 10.0.0.0/24, 11.0.0.0/24,100.0.0.1/32, 100.0.20.1/32, and 192.168.1.1/32
• C. 100.0.20.1/32, 192.168.1.1/32, and 100.0.0.1/32
• D. 100.0.20.1/32

Answer: B

NEW QUESTION 21
What are two methods for decreasing the size of an OSPF link-state database (LSDB)? (Choose two.)

• A. Ensure that all routers on a shared segment are configured with a priority value of 0.
• B. Use an interface type of p2p when possible.
• C. Segment large groups of routers into areas.
• D. Change a stub area to NSSA when possible.

Answer: BC

NEW QUESTION 22
Because of recent network failures, additional circuits have been purchased. In addition, Fast reroute has been configured on critical MPLS LSPs.
When the next failure occurs, which two time intervals will affect fast reroute? (Choose two.)

• A. The amount of time required to reroute the traffic onto the detour
• B. The amount of time to detect a link or node failure
• C. The amount of time required to recalculate the best detour
• D. The amount of time it takes to ping the gateway on the detour link

Answer: AB

NEW QUESTION 23
Which statement is true about routing instances on Junos devices?

• A. Routing information cannot be shared between routing instance.
• B. Each routing protocol runs in a separate routing instance.
• C. Junos device support only one routing instance.
• D. Each routing instance is a unique grouping of routing tables, interfaces, and routing protocol parameters.

Answer: D

NEW QUESTION 24
Which two fields of a hello packet must match on both routers when forming an OSPF adjacency? (Choose two.)

• A. Hello interval
• B. Designated route
• C. Router priority
• D. Network mask

Answer: AD

NEW QUESTION 25
Click the Exhibit.


You have just configured a GRE tunnel, but you notice that the GRE tunnel is flapping. Referring to the exhibit, which two would you take to solve this problem? (Choose two.)

• A. Add a specific static route to the local peer’s network with the remote devices’loopback address as the next-hop gateway.
• B. Add a specific route to the remote device’s loopback address with the next-hop devicedefined as the next-hop gateway.
• C. Set the GRE interface with a larger TTL value.
• D. Remove the existing 192.168.2.0/30 static route.

Answer: BD

NEW QUESTION 26
......