Want to know Exambible 200-125 Exam practice test features? Want to lear more about Cisco CCNA Cisco Certified Network Associate CCNA (v3.0) certification experience? Study Tested Cisco 200-125 answers to Regenerate 200-125 questions at Exambible. Gat a success with an absolute guarantee to pass Cisco 200-125 (CCNA Cisco Certified Network Associate CCNA (v3.0)) test on your first attempt.

2021 Dec 200-125 free exam questions

Q21. - (Topic 4) 

Refer to the exhibit. 

The speed of all serial links is E1 and the speed of all Ethernet links is 100 Mb/s. A static route will be established on the Manchester router to direct traffic toward the Internet over the most direct path available. What configuration on the Manchester router will establish a route toward the Internet for traffic that originates from workstations on the Manchester LAN? 

A. ip route 0.0.0.0 255.255.255.0 172.16.100.2 

B. ip route 0.0.0.0 0.0.0.0 128.107.1.1 

C. ip route 0.0.0.0 255.255.255.252 128.107.1.1 

D. ip route 0.0.0.0 0.0.0.0 172.16.100.1 

E. ip route 0.0.0.0 0.0.0.0 172.16.100.2 

F. ip route 0.0.0.0 255.255.255.255 172.16.100.2 

Answer:


Q22. - (Topic 7) 

What Cisco IOS feature can be enabled to pinpoint an application that is causing slow network performance? 

A. SNMP 

B. Netflow 

C. WCCP 

D. IP SLA 

Answer:


Q23. - (Topic 3) 

Which IPv6 address is the equivalent of the IPv4 interface loopback address 127.0.0.1? 

A. ::1 

B. :: 

C. 2000::/3 

D. 0::/10 

Answer:


Q24. - (Topic 3) 

How is an EUI-64 format interface ID created from a 48-bit MAC address? 

A. by appending 0xFF to the MAC address 

B. by prefixing the MAC address with 0xFFEE 

C. by prefixing the MAC address with 0xFF and appending 0xFF to it 

D. by inserting 0xFFFE between the upper three bytes and the lower three bytes of the MAC address 

E. by prefixing the MAC address with 0xF and inserting 0xF after each of its first three bytes 

Answer:


Q25. - (Topic 2) 

Refer to the exhibit. 

A frame on VLAN 1 on switch S1 is sent to switch S2 where the frame is received on VLAN 2. What causes this behavior? 

A. trunk mode mismatches 

B. allowing only VLAN 2 on the destination 

C. native VLAN mismatches 

D. VLANs that do not correspond to a unique IP subnet 

Answer:


Avant-garde 200-125 study guide:

Q26. - (Topic 9) 

Which command can you enter to display the hits counter for NAT traffic? 

A. show ip nat statistics 

B. debug ip nat 

C. show ip debug nat 

D. clear ip nat statistics 

Answer:


Q27. - (Topic 9) 

Which feature builds a FIB and an adjacency table to expedite packet forwarding? 

A. Cisco Express Forwarding 

B. process switching 

C. fast switching 

D. cut-through 

Answer:


Q28. - (Topic 4) 

Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.) 

A. RAM 

B. NVRAM 

C. flash memory 

D. HTTP server 

E. TFTP server 

F. Telnet server 

Answer: C,E 


Q29. - (Topic 4) 

Refer to the exhibit. 

Based on the exhibited routing table, how will packets from a host within the 192.168.10.192/26 LAN be forwarded to 192.168.10.1? 

A. The router will forward packets from R3 to R2 to R1. 

B. The router will forward packets from R3 to R1 to R2. 

C. The router will forward packets from R3 to R2 to R1 AND from R3 to R1. 

D. The router will forward packets from R3 to R1. 

Answer:


Q30. - (Topic 8) 

The command frame-relay map ip 10.121.16.8 102 broadcast was entered on the router. Which of the following statements is true concerning this command? 

A. This command should be executed from the global configuration mode. 

B. The IP address 10.121.16.8 is the local router port used to forward data. 

C. 102 is the remote DLCI that will receive the information. 

D. This command is required for all Frame Relay configurations. 

E. The broadcast option allows packets, such as RIP updates, to be forwarded across the PVC. 

Answer: