Loads of cost-free 300-075 presentations come in diverse internet sites and you also may possibly down load 300-075 review courses to recieve a very good traction across the inquiries enquired within the 300-075 exam. Diverse on-line coaching choices accessible and you also may possibly make a choice that would offer a great software. A site with an excellent software would certainly have a very good knowing conditions. Apart from you software you must likewise be wary of choices similar to the problem high quality and in addition how valuable its for preparing for the large examination!

2021 Nov cisco 300-075 ciptv2:

Q51. Refer to the exhibit. 

How many calls are permitted by the RSVP configuration? 

A. one G.711 call 

B. two G.729 calls 

C. one G.729 call and one G.711 call 

D. eight G.729 calls 

E. four G.729 calls 

Answer: B 

Explanation: 

Incorrect Answer: A, C, D, E In performing location bandwidth calculations for purposes of call admission control, Cisco Unified Communications Manager assumes that each call stream consumes the following amount of bandwidth: 

.G.711 call uses 80 kb/s. 

.G.722 call uses 80 kb/s. 

.G.723 call uses 24 kb/s. 

.G.728 call uses 26.66 kb/s. 

.G.729 call uses 24 kb/s. 

Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a02cac.html #wpxref28640 


Q52. The relationship between a Region and a Location is that the Region codec parameter is used between a Region and its configured Locations. 

A. TRUE 

B. FALSE 

Answer: B 

Explanation: 

Locations work in conjunction with regions to define the characteristics of a network link. Regions define the type of compression (G.711, G.722, G.723, G.729, GSM, or wideband) that is used on the link, and locations define the amount of available bandwidth for the link Link: 

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a02cac.html #wp1033331 


Q53. Refer to the exhibit. 

The HQ Cisco Unified Communications Manager has been configured for end-to-end 

RSVP. The BR Cisco Unified Communications Manager has been configured for local 

RSVP. 

RSVP between the locations assigned to the IP phones and SIP trunks at each site are configured with mandatory RSVP. When a call is placed from the IP phone at HQ to the BR phone at the BR site, which statement is true? 

A. The Cisco Unified Communications Manager at HQ will fall back to local RSVP and place the call. No RSVP end-to-end will occur. 

B. RSVP end-to-end will occur. 

C. The Cisco Unified Communications Manager at HQ will use end-to-end RSVP. The BR Cisco Unified Communications Manager will use local RSVP. 

D. The call will fail. 

E. The call will proceed as a normal call with no RSVP reservation. 

Answer: D 

Explanation: 

Incorrect Answer: A, B, C A possible cause is that the same router is being used as the calling and called RSVP agents, and that router is not running the latest IOS version, which supports loopback on RSVP reservation. Make sure that the router is running the latest IOS version. Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_6_1/ccmsys/a02rsvp.html #wp1155102 


Q54. Refer to the exhibit. 

Which trunks would be most suitable for Connection Y? 

A. an H.225 trunk (gatekeeper-controlled) 

B. intercluster trunk (gatekeeper-controlled) 

C. a SIP trunk on the U.S. cluster and an intercluster trunk on the remote cluster 

D. intercluster trunk (nongatekeeper-controlled) 

E. No extra connections are required. As long as IP connectivity exists, you need only configure a route pattern for each site. The Cisco Unified Communications Manager will automatically forward the calls over the WAN if the destination directory number is not registered locally. 

Answer: D 


Q55. Refer to the exhibit. 

The HQ site uses area code 650. The BR1 site uses area code 408. The long distance national code for PSTN dialing is 1. To make a long distance national call, an HQ or BR1 user dials access code 9, followed by 1, and then the 10-digit number. 

Both sites use MGCP gateways. AAR must use globalized call routing using a single route pattern. Assume that all outgoing PSTN numbers are localized at the egress gateway as shown in the exhibit. 

Which partition should be configured in the AAR CSS applied at the phones? 

A. PSTN partition 

B. LD partition 

C. The HQ AAR CSS must include a partition assigned to route pattern 91408XXXXXXX. The BR1 AAR CSS must include a partition assigned to route pattern 91650XXXXXXX. 

D. AAR CSS must contain translation pattern 9.1[2-9]XX[2-9]XXXXXX for each site that must be globalized. Otherwise the called numbers will not be localized at the egress gateway. 

Answer: A 


Up to the minute voice tut 300-075 ciptv2:

Q56. Which two options enable routers to provide basic call handling support for Cisco Unified IP Phones if they lose connection to all Cisco Unified Communications Manager systems? 

(Choose two.) 

A. SCCP fallback 

B. Cisco Unified Survivable Remote Site Telephony 

C. Cisco Unified Communications Manager Express 

D. MGCP fallback 

E. Cisco Unified Communications Manager Express in SRST mode 

Answer: B,E 


Q57. When implementing a dial plan for multisite deployments, what must be present for SRST to work successfully? 

A. dial peers that address all sites in the multisite cluster 

B. translation patterns that apply to the local PSTN for each gateway 

C. incoming and outgoing COR lists 

D. configuration of the gateway as an MGCP gateway 

Answer: B 


Q58. Which statement about H.323 Gatekeeper Call Admission Control is true? 

A. Gatekeeper Call Admission Control applies to centralized Cisco Unified Communications deployments that use locations based Call Admission Control. 

B. Gatekeeper Call Admission Control applies to distributed Cisco Unified Communications deployments. 

C. Gatekeeper Call Admission Control applies only to distributed Cisco Unified Communications Express deployments. 

D. Gatekeeper Call Admission Control setting is configured in Cisco Unified Communications Manager. 

Answer: B 

Explanation: 

Incorrect Answer: A, C, D in distributed call processing deployments on a simple hub-and-spoke topology, you can implement call admission control with a Cisco IOS gatekeeper. In this design, the call processing agent (which could be a Unified CM cluster, Cisco Unified Communications Manager Express (Unified CME), or an H.323 gateway) registers with the Cisco IOS gatekeeper and queries it each time the agent wants to place an IP WAN call. Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/cac.html#wp1044743 


Q59. In what Cisco solution is Simple Network-Enabled Auto Provision technology used? 

A. Cisco Unified Gateway Duplication 

B. Cisco Unified CallManager Redundancy 

C. Cisco Unified SRST 

D. Cisco Unified Call Survivability 

Answer: C 

Explanation: 

Incorrect Answer: A, B, D When the system automatically detects a failure, Cisco Unified SRST uses Simple Network Auto Provisioning (SNAP) technology to auto-configure a branch office router to provide call processing for the Cisco Unified IP phones that are registered with the router Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmesr st.html 


Q60. Refer to the following exhibit. 

Which Cisco IOS SAF Forwarder configuration is correct? 

A. Exhibit A 

B. Exhibit B 

C. Exhibit C 

D. Exhibit D 

Answer: A 

Explanation: 

Incorrect Answer: B, C, D Summary steps to configure IOS SAF forwarder is given below 

1. enable 

2. configure terminal 

3. router eigrp virtual-instance-name 

4. service-family {ipv4 | ipv6} [vrf vrf-name] autonomous-system autonomous-system-number 

5. topology base 

6. external-client client_label 

7. exit-sf-topology 

8. exit-service-family

9. exit

10. service-family external-client listen {ipv4 | ipv6} tcp_port_number

11. external-client client-label

12. username user-name

13. password password-name 

14.