Actualtests offers free demo for hpe6-a41 exam. "Applying Aruba Switching Fundamentals for Mobility", also known as hpe6-a41 exam, is a HP Certification. This set of posts, Passing the HP hpe6-a41 exam, will help you answer those questions. The hpe6-a41 Questions & Answers covers all the knowledge points of the real exam. 100% real HP hpe6-a41 exams and revised by experts!
Free hpe6-a41 Demo Online For HP Certifitcation:
NEW QUESTION 1
A network administrator configures MSTP on an ArubaOS switch. The administrator wants to ensure that this switch is always the root for instance 1.
What should the administrator do to accomplish this?
- A. Specify priority 15 for spanning tree instance 1.
- B. Specify spanning tree cost 0 on all switch ports that connect to other switches that use instance 1.
- C. Specify priority 0 for spanning tree instance 1.
- D. Specify spanning tree cost 15 on all switch ports that connect to other switches that use instance 1.
Answer: C
NEW QUESTION 2
Refer to the exhibit.
This switch currently assigns all VLANs to MSTP instance 0 or the Internal Spanning Tree (IST). Which statement correctly describes interface 21?
- A. The interface is down at Layer 2; it is not available for sending or receiving any traffic.
- B. The interface does not forward or accept data traffic, but it is ready to start forwarding if interface 19 fails.
- C. The interface is an edge port but has received Bridge Protocol Data Units (BPDUs), so it is disabled.
- D. The interface does not support spanning tree: it is possible that it will introduce a loop in the network.
Answer: B
NEW QUESTION 3
Refer to the exhibit.
Based on the exhibit, what is the problem?
- A. An issue causes the spanning tree to converge and re-converge again and again.
- B. Interface 25 on Switch-1 is incorrectly configured as an STP edge port and causes a loop to occur.
- C. Interface 25 on Switch-1 does not support the correct VLANs and prevents the interface from receiving the correct STP role.
- D. Switch-1 and another switch are configured with the same spanning tree priority and cause the root election to occur again and again.
Answer: A
NEW QUESTION 4
Refer to the exhibit.
Device 1 needs to send traffic to Device 2, and it sends an ARP request in preparation. Which devices process this ARP request?
- A. all devices in VLAN 2, 192.168.2.0/24 subnet
- B. all devices connected to Switch-2
- C. all devices in VLAN 3, 192.168.3.0/24 subnet
- D. all devices in this network
Answer: A
NEW QUESTION 5
Which type of 802.11 wireless network can be hosted by an endpoint device such as a laptop?
- A. a wireless distribution system
- B. an ad hoc network
- C. a wireless mesh or bridge
- D. an infrastructure network
Answer: B
NEW QUESTION 6
Which security options for a WLAN can authenticate either the computer or the user?
- A. Open with MAC authentication
- B. MAC authentication with WPA2 Enterprise (802.1X) fail-thru
- C. Personal (preshared key) authentication with WEP
- D. Personal (preshared key) authentication with WPA2
Answer: B
NEW QUESTION 7
Refer to the exhibit.
Which feature should the network administrator configure on the Virtual Switching Framework (VSF) fabric to prevent issues if Links 1 and 2 fail?
- A. Graceful OSPF (non-stop forwarding)
- B. Multi-Active Detection (MAD)
- C. Distributed trunking
- D. Virtual Router Redundancy Protocol (VRRP)
Answer: B
NEW QUESTION 8
Which security benefit does SNMPv3 offer that SNMPv2 does not offer?
- A. SSL encryption
- B. Scopes
- C. Data confidentially
- D. RADIUS groups
Answer: C
NEW QUESTION 9
A network administrator wants to place desktops connected to an ArubaOS switch in VLAN5. The desktops have no awareness of VLANs. How should the administrator assign desktops to the VLAN?
- A. Make switch ports connected to desktops tagged members of VLAN5.
- B. Make VLAN5 the Default VLAN on the switch before the desktops connect to the switch ports.
- C. Make VLAN5 the Primary VLAN on the switch.
- D. Make switch ports connected to desktops untagged members of VLAN5.
Answer: D
NEW QUESTION 10
A network administrator connects an Aruba Instant AP (IAP) to an ArubaOS switch but cannot connect the AP to the Instant cluster that exists. The administrator wants to check the IAP management IP address and software version from the ArubaOS switch CLI. To obtain this information, what should the administrator ensure is enabled on the switch and switch interfaces?
- A. SNMP
- B. ARP
- C. Device profiles
- D. LLDP
Answer: D
NEW QUESTION 11
A network administrator wants to be able to access an Aruba Instant cluster at the same IP address even if the current master fails.
How can the administrator achieve this goal?
- A. Configure a VC IP address that is a reserved IP address in the AP’s subnet.
- B. Configure the AirWave IP address in the instant cluster System > Admin settings.
- C. Assign static IP addresses, rather than DHCP ones, to all APs in the instant cluster.
- D. Assign a static IP addresses, rather than a DHCP one, to the AP that is elected master.
Answer: A
NEW QUESTION 12
Refer to the exhibit.
MSTP is implemented in the topology shown in the exhibit, and all the switches are in the same region. The network administrator does not want to use the Internal Spanning Tree (IST) or instance 0 for production traffic.
How many non-IST spanning tree instances does this network need in order to have effective load sharing on the uplinks from the access switches?
- A. two
- B. three
- C. four
- D. five
Answer: C
NEW QUESTION 13
Refer to the exhibit.
Exhibit 1.
Exhibit 2.
Which devices can communicate with each other at Layer 2?
- A. Devices 1 and 2 can communicate at Layer 2; Devices 3 and 4 can communicate at Layer 2.
- B. Devices 2 and 3 can communicate at Layer 2.
- C. Devices 1 and 3 can communicate at Layer 2.
- D. Devices 1 and 4 can communicate at Layer 2; Devices 2 and 3 can communicate at Layer 2.
Answer: B
NEW QUESTION 14
A network administrator wants to form a cluster with several Aruba Instant APs. What is required to achieve this goal?
- A. All APs must be pre-configured with WLANs with the same SSID.
- B. All APs must be in the same regulatory domain.
- C. All APs must operate on the same radio channel.
- D. All APs must be the same model.
Answer: B
NEW QUESTION 15
A manager password is configured on an ArubaOS switch. The network administrator wants to ensure managers only use SSH to connect to the ArubaOS switch for CLI access. Which step should the administrator complete to accomplish this?
- A. Enter the command no telnet-server.
- B. Enter the commend include-credentials.
- C. Enter the command ip ssh.
- D. Enter the command secure-vty.
Answer: A
NEW QUESTION 16
Which security option for a WLAN provides the best access control security?
- A. MAC authentication with WPA-PSK
- B. WPA2 Enterprise (802.1X)
- C. WPA2 Personal (preshared key)
- D. MAC authentication with WPA2 Enterprise (802.1X) fail-thru
Answer: B
NEW QUESTION 17
A network administrator configures OSPF in a network with ArubaOS switches. The administrator is concerned that a rogue device might connect to an access layer switch and introduce OSPF routes to the company’s routing topology. The access VLANs do not contain additional routers.
What should the administrator do so switches do not form an adjacency with rogue devices on the access VLANs?
- A. Implement BPDU filtering on interfaces assigned to these VLANs.
- B. Configure the VLANs as passive OSPF interfaces.
- C. Configure the interfaces with the highest OSPF DR priority.
- D. Apply outbound routing policies to filter routes on the VLANs.
Answer: B
NEW QUESTION 18
A company has a single routing protocol environment.
What is one reason to use OSPF routing instead of static routing?
- A. OSPF allows ArubaOS switches to use default routes, while static routes cannot use 0.0.0.0/0 as the destination network.
- B. OSPF has a lower default administrative distance than static routing on ArubaOS switches.
- C. OSPF reduces the risk of accidentally introducing routing loops, while static routing does not.
- D. OSPF permits load sharing traffic over multiple routes, while static routing does not.
Answer: C
NEW QUESTION 19
A network administrator needs to set up a static LACP link aggregation. How should the administrator configure the VLAN settings for the link aggregation?
- A. Configure the VLANs on the physical interface with the lowest port ID before link aggregation setup.
- B. Configure the VLANs on both physical interfaces after link aggregation setup.
- C. Configure the VLANs on the link aggregation interface after the link aggregation setup.
- D. Configure the VLANs on both physical interfaces before link aggregation setup.
Answer: A
NEW QUESTION 20
A network administrator uses the console to access an ArubaOS core switch and wants to find the management IP address of another ArubaOS switch that is currently connected to port B1. Which information should the administrator review?
- A. interface with the use of the show interface command
- B. LLDP with the use of the show lldp info remote-device command
- C. ARP with the use of the show arp command
- D. device profile with the use of the show device-profile status command
Answer: B
NEW QUESTION 21
......
100% Valid and Newest Version hpe6-a41 Questions & Answers shared by Certleader, Get Full Dumps HERE: https://www.certleader.com/hpe6-a41-dumps.html (New 125 Q&As)