Proper study guides for Improve Cisco Interconnecting Cisco Networking Devices Part 2 (ICND2) certified begins with Cisco 200-101 preparation products which designed to deliver the High value 200-101 questions by making you pass the 200-101 test at your first time. Try the free 200-101 demo right now.

2021 Feb icnd1 and icnd2 vs ccna:

Q11. Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used? 

A. hop count 

B. administrative distance 

C. link bandwidth 

D. link delay 

E. link cost 

Answer: B 


Q12. What does the frame-relay interface-dlci command configure? 

A. local DLCI on the subinterface 

B. remote DLCI on the main interface 

C. remote DCLI on the subinterface 

D. local DLCI on the main interface 

Answer: A 


Q13. The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the graphic. There is concern that a lack of router resources is impeding internetwork performance. As part of examining the router resources, the OSPF DRs need to be known. All the router OSPF priorities are at the default and the router IDs are shown with each router. Which routers are likely to have been elected as DR? (Choose two.) 

A. Corp-1 

B. Corp-2 

C. Corp-3 

D. Corp-4 

E. Branch-1 

F. Branch-2 

Answer: DF 


Q14. Which command enables IPv6 forwarding on a Cisco router? 

A. ipv6 local 

B. ipv6 host 

C. ipv6 unicast-routing 

D. ipv6 neighbor 

Answer: C 


Q15. Refer to the exhibit. 

Given the output from the show ip eigrp topology command, which router is the feasible successor? 

A) 

B) 

C) 

D) 

A. Exhibit A 

B. Exhibit B 

C. Exhibit C 

D. Exhibit D 

Answer: B 


Latest ccna vs icnd1 and icnd2:

Q16. A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default characteristics. Each process learns a route to the same remote network. If there are no static routes to the destination and none of the routes were redistributed, which route will be placed in the IP routing table? 

A. the route learned through EIGRP 

B. the route learned through OSPF 

C. the route learned through RIP 

D. the route with the lowest metric 

E. all three routes with the router load balancing 

Answer: A 


Q17. DRAG DROP 

Answer: 


Q18. Which two statements about using the CHAP authentication mechanism in a PPP link are true? (Choose two.) 

A. CHAP uses a two-way handshake. 

B. CHAP uses a three-way handshake. 

C. CHAP authentication periodically occurs after link establishment. 

D. CHAP authentication passwords are sent in plaintext. 

E. CHAP authentication is performed only upon link establishment. 

F. CHAP has no protection from playback attacks. 

Answer: BC 


Q19. A static map to the S-AMER location is required. Which command should be used to create this map? 

A. frame-relay map ip 172.30.0.3 825 broadcast 

B. frame-relay map ip 172.30.0.3 230 broadcast 

C. frame-relay map ip 172.30.0.3 694 broadcast 

D. frame-relay map ip 172.30.0.3 387 broadcast 

Answer: B 


Q20. Refer to the exhibit. 

C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration? 

A. These commands need to be added to the configuration: C-router(config)# router eigrp 123 C-router(config-router)# network 172.19.0.0 

B. These commands need to be added to the configuration: C-router(config)# router ospf 1 C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0 

C. These commands need to be added to the configuration: C-router(config)# router rip C-router(config-router)# network 172.19.0.0 

D. No further routing configuration is required. 

Answer: D