It is impossible to pass VMware 2V0-622D exam without any help in the short term. Come to us soon and find the most advanced, correct and guaranteed . You will get a surprising result by our .

Check 2V0-622D free dumps before getting the full version:

NEW QUESTION 1
Which external backup target can be used for vSphere Data Protection 6.1?

  • A. NetApp Metro Cluster
  • B. Dell EMCData Domain
  • C. IBM SVC
  • D. Hitachi USP VM

Answer: B

NEW QUESTION 2
The storage vendor recommends adjusting the Fibre Channel HBA queue depth to resolve a performance problem. Which esxcli namespace can a vSphere Administratoruse to adjust the queue depth?

  • A. esxcli storage core device
  • B. esxclisystem module parameters
  • C. esxcli storage core adapter
  • D. esxcli system module set

Answer: A

NEW QUESTION 3
An administrator cannot enable multi-processor Fault Tolerance (SMP-FT) for a virtual machine. Which are two possible causes for this? (Choose two.)

  • A. The virtual machine is running on a vSAN datastore.
  • B. The Fault Tolerance network is using a 10Gbit uplink.
  • C. The virtual machine has 6 vCPUs assigned.
  • D. The virtual machine has a 1TB VMDK attached.
  • E. The virtual machine has snapshots present.

Answer: CE

NEW QUESTION 4
An administrator has decided to use Auto Deploy in the environment.
Which two considerations must be taken into account before configuring Auto Deploy? (Choose two.)

  • A. Hosts in a cluster must be connected to a Distributed Switch.
  • B. Host profiles are not supported when using Auto Deploy.
  • C. DHCP must be configured to support PXE boot.
  • D. Storage DRS must be enabled.
  • E. A TFTP server must be setup and running.

Answer: CE

NEW QUESTION 5
What counter should an administrator check to determine if a virtual machine is ballooning?

  • A. swapinRate
  • B. vmmemctl
  • C. vmmemctltarget
  • D. swapped

Answer: B

Explanation: Memory Ballooning is the memory reclamation technique used by hypervisor to reclaim the memory back from the virtual machine.
When ESXi host running low on physical memory, It uses ballooning driver (vmmemctl.sys) to determine the how much memory from virtual machines can be get back to prevent the hypervisor swapping.

NEW QUESTION 6
A scripted upgrade of ESXi fails due to an incorrect parameter in the upgrade script. What file must the administrator modify to correct the problem?

  • A. boot.cfg
  • B. vmreconfig.pl
  • C. ks.cfg
  • D. hostinfo.pl

Answer: A

NEW QUESTION 7
Which are three prerequisites for using UEFI secure boot? (Choose three.)

  • A. Virtual machine with EFI firmware
  • B. Virtual Hardware version 12
  • C. Virtual Machine with BIOS firmware version 6
  • D. Virtual Hardware version 13
  • E. Operating system that supports UEFI secure boot

Answer: ADE

Explanation: Verify that the virtual machine operating system and firmware support UEFI boot. EFI firmware
Virtual hardware version 13 or later.
Operating system that supports UEFI secure boot.
You need VirtualMachine.Config.Settings privileges to enable or disable UEFI secure boot for the virtual machine.
https://docs.vmware.com/en/VMware-vSphere/6.5/com.vmware.vsphere.security.doc/GUID-898217D4-689D-4

NEW QUESTION 8
An attempt to delete NFS datastore from an ESXI host returns the error: Sysinfo error on operation returned the following status: Busy
Which two statements could explain this failure? (Choose two.)

  • A. Storage IO Control is enabled on NFS datastore.
  • B. NFS datastore is a part of Storage DRS Cluster.
  • C. NFS datastore has running or registered virtual machines.
  • D. NFS.VolumeRemountFrequency value is set to 30.

Answer: AC

Explanation: The busy status indicated that either storage I/O control is enabled on NFS datastore or the NFS datastore is running on registered virtual machines. In both cases, sysinfo error on operation will be returned with busy status.

NEW QUESTION 9
An administrator must collect diagnostic information following a failed ESXi host upgrade. Which command should the administrator run?

  • A. vm-support
  • B. Get-Esxtop
  • C. vicfg-syslog
  • D. esxtop -R vm-support_dir_path

Answer: A

NEW QUESTION 10
When troubleshooting VMware vCenter Server issues, which logging level provides maximum detail?

  • A. info
  • B. trivia
  • C. error
  • D. verbose

Answer: B

NEW QUESTION 11
Which statement is true regarding Network-Aware DRS?

  • A. Network-Aware DRS will perform load-balancing based on the communication of virtual machines with one another.
  • B. Network-Aware DRS is enabled through DRS advanced options.
  • C. Network-Aware DRS only generated suggested moves; administrators must go in and accept each Network-Aware DRS suggestion manually.
  • D. Network-Aware DRS will perform a final check during regular DRS load-balancing to ensure that the destination host is not network saturated.

Answer: D

NEW QUESTION 12
An administrator has a large boot from SAN cluster and wants to ensure consistent configuration by using host profiles. What special considerations are required for boot from SAN hosts?

  • A. Host profiles are incompatible with boot from SAN hosts.
  • B. Change the "Device is shared clusterwide" setting to "false" in the host profile.
  • C. Verify that the boot LUN is correctly identified as the boot device in the host profile.
  • D. The boot from SAN device must report as a local device.

Answer: C

NEW QUESTION 13
Which component must be deployed before using encrypted virtual machines in a vSphere 6.5 environment?

  • A. vCenter Server must use CA signed certificates
  • B. a host with supported Trusted Platform Module
  • C. supported password vault
  • D. External Key Management Server

Answer: D

NEW QUESTION 14
Which are the two network requirements for a VMware vSAN 6.5 cluster? (Choose two.)

  • A. Multicast must be enabled on the physical switches and routers that handle vSAN traffic.
  • B. vSAN requires IPv6 only.
  • C. All hosts must have a dedicated 40GbE NIC.
  • D. The vSAN network supported IPv4 or IPv6.
  • E. vSAN requires IPv4 only.

Answer: AD

Explanation: https://docs.vmware.com/en/VMware-vSphere/6.5/com.vmware.vsphere.virtualsan.doc/GUID-AFF133BC-F4B
http://cormachogan.com/2014/01/21/vsan-part-15-multicast-requirement-for-networking-misconfiguration-detec

NEW QUESTION 15
What two methods are used to configure VMware vSphere Storage I/O Control shares and limits? (Choose two.)

  • A. Assign shares and limits to VM virtual disks.
  • B. Assign shares and limits to Storage DRS clusters.
  • C. Assign shares and limits to datastores.
  • D. Assign shares and limits using VM storage policies.

Answer: AD

Explanation: https://docs.vmware.com/en/VMware-vSphere/6.5/com.vmware.vsphere.resmgmt.doc/GUID-25C3D9FE-3A9D https://docs.vmware.com/en/VMware-vSphere/6.5/com.vmware.vsphere.resmgmt.doc/GUID-614F2F1C-36CE-

NEW QUESTION 16
An administrator has recently upgraded from vSphere 6.0 to 6.5, and can no longer see the software iSCSI named vmhba33.
Which could be the reason for this?

  • A. The upgrade has changed the vmhba name.
  • B. vSphere 6.5 automates iSCSI configurations.
  • C. vSphere 6.5 no longer supports software iSCSI.
  • D. The upgrade has deleted the vmhba.

Answer: A

NEW QUESTION 17
Which statement is correct when migrating from a Windows vCenter Server to the vCenter Server Appliance 6.5?

  • A. Migration deployments do not migrate local OS users from the source vCenter Server.
  • B. Migration deployments support DHCP on the source vCenter Server.
  • C. Migration deployments allow the source vCenter Server to remain powered on afterwards.
  • D. Migration deployments support custom ports for all services on the source vCenter Server.

Answer: A

NEW QUESTION 18
What configuration option would ensure that a virtual NUMA topology is defined on VMs having more than eight virtual CPUs?

  • A. cupid.coresPerSocket
  • B. numa.vcpu.maxPerVirtualNode
  • C. numa.vcpu.min
  • D. numa.vcpu.followcoresocket

Answer: B

NEW QUESTION 19
The vSphere HA agent has been in the "Agent Unreachable" state on a single slave ESXi host for over a minute. The master and slave ESXi hosts are connected to the vCenter Server Appliance.
Which should be the first step for validation the network configuration?

  • A. Log into the affected slave ESXi host via console or SSH and attempt to ping the master ESXi host over the vSphere HA network.
  • B. Log into the master ESXi host via console or SSH and attempt to ping the vCenter Server Appliance over the vSphere HA network.
  • C. Log into the affected slave ESXi host via console or SSH and attempt to ping the vCenter Server Appliance over the Fault Tolerance network.
  • D. Log into the vCenter Server Appliance via console or SSH and attempt to ping the affected slave ESXi host.

Answer: D

NEW QUESTION 20
How can a vSphere administrator ensure that a set of virtual machines run on different hosts in a DRS cluster?

  • A. Add the VMs to a vApp.
  • B. Use a VM-Host affinity rule.
  • C. Place the VMs in different folders.
  • D. Use a VM-VM affinity rule.

Answer: D

P.S. Easily pass 2V0-622D Exam with 269 Q&As 2passeasy Dumps & pdf Version, Welcome to Download the Newest 2passeasy 2V0-622D Dumps: https://www.2passeasy.com/dumps/2V0-622D/ (269 New Questions)