High value of 300-360 brain dumps materials and resource for Cisco certification for IT examinee, Real Success Guaranteed with Updated 300-360 pdf dumps vce Materials. 100% PASS Designing Cisco Wireless Enterprise Networks exam Today!


♥♥ 2021 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 300-360 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 300-360 Exam Dumps (PDF & VCE):
Available on: http://www.surepassexam.com/300-360-exam-dumps.html

Q11. The AP has been configured property for a VoWLAN survey The RF environment contains a noise of -87 to -90 dBm. What is the target value for the cell edge reading?

A. -62 dBm

B. -67 dBm

C. -60 dBm

D. -70 dBm

Answer: B


Q12. A customer has dual-band devices that they want to use 40 MHz channels. If the customer is using Cisco 3600 Series access points with a 5508 controller. Which setting assists with this change?

A. Enable band select globally.

B. Enable aggressive load balancing.

C. Disable lower data rates on 802 .11G GHz radios.

D. Disable overlapping 802.11G channels.

Answer: A


Q13. An engineer must design wireless coverage in thick-walled stairwells. Which information should the engineer refer to when determining where APs can be installed?

A. Local or National Building Code

B. IEEE

C. BICSI TDMM

D. Cisco Hardware Installation Guide

Answer: D


Q14. A network engineer is configuring QoS with a DSCP value of 46. To which queue must the CoS be mapped for priority queuing of the voice frames?

A. 1

B. 2

C. 5

D. 4

E. 3

Answer: C


Q15. Which two steps are associated with the active portion of the audit when a post-installation audit is performed with an auditing tool such as Ekahau? (Choose two.)

A. Check for co-channel interference by standing near an access point on one channel and watching for other access points that are on the same channel.

B. Verify smooth roaming.

C. Check to see if the signal level on other access points that are heard on the same channel is at least 19dBm weaker than the access point that you are next to.

D. Check that all channels are supported by the APs, regardless of client capabilities.

E. Verify that the network traffic of physical data rate and packet loss meets user requirements.

Answer: B,E


Q16. A customer has a business-critical voice network and wants to be alerted whenever voice clients move out of a coverage area and experience RSSI below -67 dBm on the 5 GHz band. Which option can be configured on the wireless controller to alert network administrators when this limit is surpassed?

A. EDCA; voice optimized

B. SIP voice sample interval

C. 802.11a voice RSSI coverage threshold

D. traffic stream metrics

Answer: C


Q17. Which three recommendations must be taken into consideration when an engineer is installing a new Voice WLAN? (Choose three.)

A. Use the Cisco wireless phone site survey client utility.

B. Use a separate Cisco Wireless Lan Controller.

C. Enable load balance on voice WLANs.

D. Maintain -67dBM as a minimal RSSI.

E. Set data for 2.4 GHz and voice for 5 GHz using separate SSIDs.

F. Enable lower data rates for 2.4-GHz data WLAN.

Answer: A,D,E


Q18. When conducting a wireless survey at a customer facility, signal attenuation in an area that is surrounded by thick glass walls is noted as 2dB. When configuring Cisco Prime Infrastructure, which obstacle should be placed in a map editor to represent the impact the glass wall will have on the RF signal in the facility?

A. heavy door

B. thick wall

C. glass

D. light wall

Answer: D

Explanation: Reference: http://www.cisco.com/c/en/us/td/docs/wireless/prime_infrastructure/1-2/configuration/guide/pi_12_cg/maps.html Table 6-4


Q19. A customer has deployed an N+N redundant wireless infrastructure. In this deployment, the access points have been salt and peppered between controllers. What configuration would be necessary to cut down on the use of mobility tunnels for voice clients?

A. mobility anchor

B. KIS based CAC

C. media session snooping

D. re-anchor roamed voice clients

Answer: D


Q20. When reviewing a design for a voice over wireless deployment, what per-call bandwidth cost should be factored in when determining maximum calls per cell using SIP and G.711u as the codec?

A. 64 bytes 

B. 8 bytes

C. 80 bytes

D. 10 bytes

Answer: C