It is more faster and easier to pass the HUAWEI H12-811_V1.0 exam by using Accurate HUAWEI HCIA-Datacom V1.0 questuins and answers. Immediate access to the Avant-garde H12-811_V1.0 Exam and find the same core area H12-811_V1.0 questions with professionally verified answers, then PASS your exam with a high score now.
Also have H12-811_V1.0 free dumps questions for you:
NEW QUESTION 1
For switches running the STP protocol, the port needs to wait for the forwarding delay in the Learning state to transform into the Forwarding state. ()
- A. True
- B. False
Answer: B
NEW QUESTION 2
As shown in the figure below, assuming that the MAC address table of SWA. is as follows, now host A. sends a data frame with a destination MAC address of MAC-B. Which of the following statements is correct? ()
- A. Forward this data frame from port G0/0/3
- B. Flood out this data frame
- C. Forward this data according to the G0/0/2 port
- D. SW
- E. Discard the data frame
Answer: C
NEW QUESTION 3
As shown in the figure. If host A has the ARp cache table of host B, then host A can ping host B. ()(True or False)
- A. True
- B. False
Answer: B
NEW QUESTION 4
Which category does the IPv6 address FE80:2E0:FCFF:FE6F:4F36 belong to? ()
- A. Link local address
- B. Global semicast address
- C. Anycast address
Answer: B
NEW QUESTION 5
The ACL on the ARG3 series routers supports two matching sequences, configuration sequence and automatic sorting. ()
- A. True
- B. False
Answer: A
NEW QUESTION 6
Layer 2 ACL can match source MAC, destination MAC, source IP, destination IP and other information. ()
- A. True
- B. False
Answer: B
NEW QUESTION 7
Which parameter is used in the spanning tree protocol for root bridge election? ()
- A. Port ID
- B. Bridge priority
- C. Root path cost
- D. Bridge ID
Answer: B
NEW QUESTION 8
The router running the OSPF protocol reaches the FULL state first, and then synchronizes the LSDB. ()
- A. True
- B. False
Answer: B
NEW QUESTION 9
As shown in the figure, you only need to configure this static route on R1, and the two hosts can communicate with each other normally.
- A. True
- B. False
Answer: B
NEW QUESTION 10
The following two configuration commands can implement router RIA. The route to the same destination 10.1.1.1.1 is active and standby:
- A. True
- B. Mistake
Answer: B
NEW QUESTION 11
If the Proto of a certain route information in the routing table is Direct, the priority of this route must be0.()
- A. True
- B. False
Answer: A
NEW QUESTION 12
What is the protocol number corresponding to the ospf protocol at the network layer? ()
- A. 89
- B. 6
- C. 1
Answer: A
NEW QUESTION 13
The administrator has configured the AR2200. Which of the following descriptions about the configuration information is correct ()
- A. The saved configuration file will be replaced by the running configuration file
- B. If the user wants to clear the next startup configuration file of the device configuration, they should select "N"
- C. If the user wants to clear the next startup configuration file of the device configuration, they should select "Y"
- D. The next startup file of the device configuration will be retained
Answer: C
NEW QUESTION 14
Which of the following statements about IPv6 RA. and RS messages are correct? ()
- A. RS is used to reply address prefix information
- B. RS is used to request address prefix information
- C. R
- D. Used to request address prefix information
- E. R
- F. Used to reply address prefix information
Answer: BD
NEW QUESTION 15
In the history of WLAN development, which of the following is not included in the main wireless protocol standards in the primary mobile office era? ()
- A. 802.11g
- B. 802.11a
- C. 802.11b
- D. 802.11ac
Answer: D
NEW QUESTION 16
The switch GE0/0/1 port configuration information is shown in the figure. Which VLAN data frame does the switch not carry when forwarding?()
- A. 10
- B. 20
- C. 30
Answer: B
NEW QUESTION 17
Which state does the 0SPF protocol use to indicate that the adjacency relationship has been established? ()
- A. Full
- B. 2-way
- C. Attempt
- D. Down
Answer: A
NEW QUESTION 18
The output information of a certain device is shown in the figure. Which of the following statements is correct? ( )
display interface G1gabitEthernet 0/0/0 G1 gabi tEthernet0/0/0 currentstate UP Line protocol current state UP Route PortThe Maximum Transmit Unit is 1000 Internet Address is 10.0.12.2/24 IP Sending Frames'Format is PRTFMT ETENT 2.Hardware address is 00e0-fc22-4fff Port Mode:FORCE COPPER SpeeD.:100, Loopback:NONE Duplex:FULL, Negotiation:DISABLE Md1 AUTO Last 300 seconds input rate 24 bits/seC.0 packets/sec Last 300 seconds output rate 24 bits /seC.0 packets/seC.*
- A. The P address of the interface is 10.0.12.2/24
- B. The MAC of the interfac
- C. The address is 00e0-fc22-4fff
- D. The working rate of this interface is 1Gbps
- E. The MTU value of this interface is 1000
Answer: ABD
NEW QUESTION 19
......
100% Valid and Newest Version H12-811_V1.0 Questions & Answers shared by Certleader, Get Full Dumps HERE: https://www.certleader.com/H12-811_V1.0-dumps.html (New 730 Q&As)