Act now and download your Cisco 642-732 test today! Do not waste time for the worthless Cisco 642-732 tutorials. Download Renovate Cisco CCNP Wireless - CUWSS exam with real questions and answers and begin to learn Cisco 642-732 with a classic professional.

2021 Dec 642-732 cuwss cbt nuggets:

Q1. After having the kick-off meeting for a new site survey project with your customer, which three factors need to be considered prior to beginning a WLAN site survey? (Choose three.) 

A. Will an additional trip to the facility to perform the initial walkthrough be required? 

B. How much time should be allocated to survey the locations for the controllers? 

C. Will any additional regulatory or safety training be required to complete the site survey? 

D. Is access available to all areas of the customer facility where the WLAN is planned to be deployed? 

E. Which types of controllers and switches will be required to fully conduct the site survey in all areas of the customer facility? 

F. Is access available to customer employees so that initial interviews can be performed? 

Answer: A,C,D 


Q2. Refer to the exhibit. Clients are being disconnected from the WLAN. Which source of interference can cause a Denial of Service? 

A. jammer 

B. microwave oven 

C. Bluetooth devices 

D. wireless video camera 

E. ZigBee device 

Answer: A 


Q3. You have completed a WLAN site survey for a customer. Which two pieces of information will need to be included in the final customer report? (Choose two.) 

A. Location and placement of application servers 

B. The number of active users that are planned to use the system in a specific area 

C. The number of APs dedicated to location services 

D. The results from customer end user interviews 

E. Analysis of WLAN signals on the networks of neighboring companies 

Answer: B,C 


Q4. A network engineer acquired a floor plan of a building, temporarily mounted an 1132 AP, associated a wireless NIC to the AP, and began documenting packet exchanges between the AP and the wireless NIC while walking throughout the facility. What best describes what the engineer was doing? 

A. Air Magnet predictive site survey 

B. Cisco Spectrum expert Survey 

C. Ekahau active site survey 

D. Air Magnet passive site survey 

Answer: C 


Q5. You have been asked to evaluate a deployed version 7.0 controller based WLAN, which includes a Cisco WCS and an MSE3310. Currently, the customer has a approximately 1900 clients and 300 RFID tags. The customer is complaining of problems tracking clients and RFID tags. What can be done to correct this problem? 

A. Increase the wIPS license on the MSE3310. 

B. Replace the MSE3310 with a MSE3355 and increase the wIPS license. 

C. Replace the MSE3310 with a MSE3355 and increase the Context-Aware license. 

D. Decrease the wIPS license on the MSE3310. 

E. Increase the Context-Aware license on the MSE3310. 

Answer: C 


Down to date 642-732 cuwss training video:

Q6. Which statement best describes an outdoor RF point-to-point antenna deployment? 

A. Both antennas must be vertically polarized. 

B. Both antennas must be horizontally polarized. 

C. There should be a 90 degree difference between antennas for best results. 

D. There should be a 180 degree difference between antennas for best results. 

E. It does not matter so long as both antennas have matching polarization. 

Answer: E 


Q7. An engineer has WLC redundancy included in WLAN design documentation, where the WLCs are loaded to half the license capacity therefore allowing half the WLCs to fail without an AP going offline at a given time. What redundancy model does this describe? 

A. N+1 

B. N+N 

C. N+N+1 

D. N+1+1 

Answer: B 


Q8. Which three statements describe WLAN RF interaction with environmental situations? (Choose three.) 

A. Outdoor rain or indoor humidity affects diffraction. 

B. Outdoor rain or indoor humidity affects attenuation. 

C. RF frequency is inversely related to attenuation. 

D. RF frequency is directly related to attenuation. 

E. The human body affects diffusion. 

F. The human body affects attenuation. 

Answer: B,D,F 


Q9. You have been contacted by a medium sized medical center to do a site survey of their existing WLAN. The current network is set up with multiple SSIDs/VLANs to separate voice and data and the networks functioning properly. The medical center would like to add Vocera voice badges to the existing VoWLAN. Which two issues need to be considered during the site survey? (Choose two.) 

A. The additional voice endpoints may increase additional load, which may increase delay in the WLAN and cause voice quality to degrade. 

B. There will not be any issues due to adding the Vocera voice badges because they are point-to-point devices and do not require the infrastructure to communicate. 

C. Verify the WLAN is multicast enabled for Vocera voice badges. 

D. To make these devices as efficient as possible, the Vocera voice badges should be placed on their own unicast SSID/VLAN. 

E. Verify the WLAN that is being used by the Vocera voice badges is configured in the WLC to use the Gold QoS value. 

Answer: A,C 


Q10. An engineer is conducting a VoWLAN survey for voice clients with a max power of 40 mW. What power level should the engineer set the AP to during the survey? 

A. 5 mW 

B. 10 mW 

C. 20 mW 

D. 30 mW 

E. 40 mW 

Answer: C