Cisco Cisco 300-360 exam is one among those nearly all favorable IT certifications which could promote the career opportunity for IT professionals. If you properly obtain the actual Cisco 300-360 certification, lots of career opportunities will certainly open up for you personally. But firstly, you should put much energy on the Cisco 300-360 exam preparation. It is a demanding career if you get ready it by yourself. The particular candidates should get full command associated with all the factors of the 300-360 certification exam. The particular Cisco 300-360 online coaching course can easily benefit you a lot inside preparing the actual Cisco certification exam. The 300-360 practice dumps contain each of the authorized knowledge items in accordance with the 300-360 exam syllabus.

2021 Feb 300-360 exam topics

Q31. An 802.11n implementation is being discussed. Users are satisfied with the potential 300- 450 Mbps throughput of new 802.11n APs. Which three bandwidth requirements are used to calculate per client bandwidth through an 802.11n AP network? (Choose three.)

A. 450 Mbps throughput is the client max for 5-GHz radio.

B. Channel bonding on 5 GHz is required for a client to have a 300 Mbps WiFi link.

C. 300 Mbps throughput is the client max for 2.4-GHz radio.

D. The remaining bandwidth is divided per device when more clients are connected to one AP.

E. 100 Mbps Ethernet switch port is a potential bottleneck.

F. CleanAir helps clear noise for 802.11n channel bonding to work.

Answer: A,C,D


Q32. An engineer is performing a predictive wireless design for a medical treatment environment, which requires data and voice services. Which of the following is a requirement for the design?

A. overlapping -72 dBm coverage from two access points

B. overlapping -67 dBm coverage from two access points

C. continuous -67 dBm coverage from one access point

D. continuous -72 dBm coverage from one access point

Answer: C


Q33. After the completion of a site survey with Ekahau Site Survey tool, using the default color palette, it is noted that multiple areas are shown as white on the heat map when viewing 5 GHz signal strength data. What does this indicate about the signal strength?

A. The area is below the minimum threshold configured on the tool.

B. The area is below the detectable level and indicates no RF signal.

C. The area is below -100 dBm at coverage cell edge.

D. The area is below -67 dBm at coverage cell edge.

Answer: A


Regenerate 300-360 test:

Q34. An engineer is performing a predictive wireless design for a Parts Distribution Center, which requires data and location services. Which three requirements are inputs to the design? (Choose three.)

A. access points with directional antennas

B. continuous -67 dBm coverage from one access point

C. overlapping -75 dBm coverage from three access points

D. overlapping -67 dBm coverage from two access points

E. access points in IPS mode

F. continuous -72 dBm coverage from one access point

G. access points in corners and along perimeters

Answer: B,C,G

Explanation: Reference: http://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/WiFiLBS- DG/wifich5.html


Q35. A customer wants to implement a wireless network in a historic location, but is concerned about the structural and aesthetic impact to the facility. Which benefit of using wireless mesh addresses these concerns?

A. Power is required only at the installation location.

B. The APs do not have LED lights.

C. More wireless channels can be supported.

D. APs do not need network connections.

Answer: D


Q36. An engineer is preparing for an outdoor wireless survey to mesh connect a distant remote building to a connected building. Which two types of antennas are appropriate for this application? (Choose two.)

A. circular polarized

B. patch

C. dish

D. Yagi

E. omni

Answer: C,D