It is more faster and easier to pass the Cisco 300-370 exam by using Best Quality Cisco Troubleshooting Cisco Wireless Enterprise Network questuins and answers. Immediate access to the Most recent 300-370 Exam and find the same core area 300-370 questions with professionally verified answers, then PASS your exam with a high score now.

2021 Feb 300-370 dumps

Q31. An engineer is troubleshooting AP join issues on a wireless infrastructure. While gathering debugs, the engineer notices that one of the commands may generate an excessive an excessive amount of data on the console. Which command causes this to occur? 

A. debug capwap detail enable 

B. debug capwap errors enable 

C. debug capwap info enable 

D. debug capwap events enable 

E. debug capwap packet enable 

F. debug capwap payload enable 

Answer: B 


Q32. An engineer is troubleshooting access point placement issues and suspects that poor placement is causing connectivity issues When running the show client detail <mac> command, the engineer notices this output Which option indicates poor access point placement? 

Refer to the exhibit. 

A. excessive number of bytes sent compared to bytes received 

B. high signal-to-noise ratio 

C. excessive number of data retries 

D. low ratio signal strength indicator 

E. duplicate received packets 

F. poor statistics for the last 90 seconds 

Answer: C,D 


Q33. Which statement describes how the Hand Select feature works on the wireless controller? Refer to the exhibit. 

A. The access point uses the load balancing feature to move the clients to 5 Ghz. 

B. The access point changes the DTIM period on the 2 4 Ghz band. 

C. The access point recommends the band in the association response to the client. 

D. The access point ignores and delays the probe request of the client on the 2 4 Ghz. 

Answer: C 


Refresh 300-370 exam question:

Q34. An AP will be deployed to an area where DHCP Option 43 is unavailable and the WLAN engineer is unable to have DNS modifications made to support this AP. Which two actions can enable the AP to join the WLC? (Choose two) 

A. Issue the clear capwap private-config command in the AP console. 

B. Pre-stage or prime the AP on the same Layer 2 VLAN as the WLC. 

C. Issue the capwap ap ip default-gateway WLC IP address command in the AP console. 

D. Issue the capwap ap ip address WLC IP address command in the AP console. 

E. Issue the capwap ap controller ip address WLC IP address command in the AP console. 

Answer: A,D 


Q35. While reviewing CleanAir data in Cisco Prime Infrastructure, an engineer notices that a wideband jammer is not sending its Interferer Security Trap correctly. The engineer determines that the default seventy level has been changed. Which value does the engineer select to reset the seventy level to its factory setting? 

A. informational 

B. major 

C. minor 

D. warning 

E. critical 

Answer: D 


Q36. A recently acquired Cisco Aironet 1550 series AP is unable to join the WLC. This message is observed on the AP console: 

AAA Authentication Failure for UserName:CC93.1981.0035 User Type: WLAN USER 

Which action must be taken for the AP to associate with the controller? 

A. Add MAC address CC93.1981.0035 to the Security AAA AP policy Authorization List. 

B. Authenticate the AP to the WLC from the console using an admin account on the WLC. 

C. Add MAC address CC93.1981.035 to the Security AAA MAC Filtering tab. 

D. Import the self-signed certificate of the AP to the Security:Certificate:LSC tab. 

E. Import the self-signed certificate of the AP to the Security:Certificate:SSC tab. 

Answer: A