♥♥ 2021 NEW RECOMMEND ♥♥
Free VCE & PDF File for Cisco 642-997 Real Exam (Full Version!)
★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions
Free Instant Download NEW 642-997 Exam Dumps (PDF & VCE):
Available on:
http://www.surepassexam.com/642-997-exam-dumps.html
Q31. Refer to the exhibit.
Which corrective action is taken to resolve the problem?
A. Trunk four VLANs on interface ethernet 199/1/1.
B. Use the shut and no shut interface ethernet 199/1/1so that the VLANs come up.
C. Place interface ethernet 199/1/1 in VLAN 4 in the N5K-2 configuration.
D. Prune all but four VLANs from vPC 199.
E. Add VLAN 4 to vPC 199.
Answer: C
Q32. Which statement about the Layer 3 card on the Cisco Nexus 5500 Series Switch is true?
A. BGP support is not provided, but RIP, EIGRP, and OSPF support is provided.
B. Up to two 4-port cards are supported with up to 160 Gb/s of Layer 3 forwarding capability.
C. Up to 16 FEX connections are supported.
D. Port channels cannot be configured as Layer 3 interfaces.
Answer: C
Q33. In the dynamic vNIC creation wizard, why are choices for Protection important?
A. They allow reserve vNICs to be allocated out of the spares pool.
B. They enable hardware-based failover.
C. They select the primary fabric association for dynamic vNICs.
D. They allow dynamic vNICs to be reserved for fabric failover.
Answer: C
Q34. Which option is a restriction of the unified ports on the Cisco UCS 6200 Series Fabric Interconnect when connecting to the unified fabric network?
A. Direct FC connections are not supported to Cisco MDS switches
B. The FCoE or Fibre Channel port allocations must be contiguous on the 6200.
C. 10-G Fibre Channel ports only use SFP+ interfaces.
D. vPC is not supported on the Ethernet ports.
Answer: B
Q35. Refer to the exhibit.
Which statement based on these two outputs that were collected 24 hours apart is true?
A. The Site 2 OTV edge device has gone down.
B. The MAC address cannot be discovered on two separate port channel interfaces.
C. The MAC address that ends in 020a moved to the local site 23 hours ago.
D. The Overlay1 IP address should be a multicast IP address.
Answer: C
Q36. Which statement about electronic programmable logic device image upgrades is true?
A. EPLD and ISSU image upgrades are nondisruptive.
B. An EPLD upgrade must be performed during an ISSU system or kickstart upgrade.
C. Whether the module being upgraded is online or offline, only the EPLD images that have different current and new versions are upgraded.
D. You can execute an upgrade or downgrade only from the active supervisor module.
Answer: D
Q37.
FabricPath switch-id is 25 and load-balance is configured for L3/L4 and rotate amount is 14 byte. What information is true about FabricPath switch-id?
A. FabricPath topology requires manual configuration of switch-id which has a range from 1 to 4095
B. Every FabricPath must have a manually configured switch-id for it to form a FabricPath topology
C. FabricPath topology requires manual configuration of switch-id which has a range from 1 to 4099
D. You do not have to manually assign a switch ID unless you are running a virtual port channel plus (vPC*) because the system assigns a switch ID for you when you enable FabricPath
Answer: B
Q38.
What is the status of FC interface associated with ethernet 1/5 indicate?
A. Trunk VSAN 11 is isolated B. Inteface vfc 5 is up and running for the assigned VSAN
C. Trunk VSAN 11 is intializing
D. VSAN to FC mapping is not working as expected
Answer: B
Q39. Which two security features are only supported on the Cisco Nexus 7000 Series Switches? (Choose two.)
A. IP source guard
B. traffic storm control
C. CoPP
D. DHCP snooping
E. Dynamic ARP Inspection
F. NAC
Answer: BF
Q40. Which two statements about Cisco Nexus 7000 line cards are true? (Choose two.)
A. M1, M2, and F1 cards are allowed in the same VDC.
B. M line cards are service-oriented and likely face the access layer and provide Layer 2 connectivity.
C. F line cards are performance-oriented and likely connect northbound to the core layer for Layer 3 connectivity.
D. M line cards support Layer 2, Layer 3, and Layer 4 with large forwarding tables and a rich feature set.
E. The F2 line card must reside in the admin VDC.
Answer: AD