Its moment to put the Examcollection Cisco 200-125 practice questions and answers directly into use. You only need to spend a bit money as well as a short span of time to practise the Cisco 200-125 exam dumps. Its worthwhile to create great attempts on the Cisco 200-125 exam preparation. Examcollection 200-125 test engine urge the candidates to crack the Cisco 200-125 exam. We provide you with the most recent as well as accurate Cisco 200-125 simulated questions as well as answers.

2021 Nov 200-125 free practice test

Q71. - (Topic 4) 

Refer to the exhibit. 

What is the effect of the configuration that is shown? 

A. It configures SSH globally for all logins. 

B. It tells the router or switch to try to establish an SSh connection first and if that fails to use Telnet. 

C. It configures the virtual terminal lines with the password 030752180500. 

D. It configures a Cisco network device to use the SSH protocol on incoming communications via the virtual terminal ports. 

E. It allows seven failed login attempts before the VTY lines are temporarily shutdown. 

Answer: D 


Q72. DRAG DROP - (Topic 4) 

Answer: 


Q73. - (Topic 7) 

Refer to the exhibit. 

A problem with network connectivity has been observed. It is suspected that the cable connected to switch port Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being disconnected? 

A. Host B would not be able to access the server in VLAN9 until the cable is reconnected. 

B. Communication between VLAN3 and the other VLANs would be disabled. 

C. The transfer of files from Host B to the server in VLAN9 would be significantly slower. 

D. For less than a minute, Host B would not be able to access the server in VLAN9. Then normal network function would resume. 

Answer: D 


Q74. - (Topic 3) 

Refer to the exhibit. 

A network administrator is adding two new hosts to SwitchA. Which three values could be used for the configuration of these hosts? (Choose three.) 

A. host A IP address: 192.168.1.79 

B. host A IP address: 192.168.1.64 

C. host A default gateway: 192.168.1.78 

D. host B IP address: 192.168.1.128 

E. host B default gateway: 192.168.1.129 

F. host B IP address: 192.168.1.190 

Answer: A,C,F 


Q75. - (Topic 9) 

Which command can you enter to view the ports that are assigned to VLAN 20? 

A. Switch#show vlan id 20 

B. Switch#show ip interface brief 

C. Switch#show interface vlan 20 

D. Switch#show ip interface vlan 20 

Answer: A 


Renewal 200-125 free download:

Q76. - (Topic 5) 

What authentication type is used by SNMPv2? 

A. HMAC-MD5 

B. HMAC-SHA 

C. CBC-DES 

D. community strings 

Answer: D 


Q77. - (Topic 3) 

Refer to the exhibit. 

What is the most efficient summarization that R1 can use to advertise its networks to R2? 

A. 172.1.0.0/22 

B. 172.1.0.0/21 

C. 172.1.4.0/22 

D. 172.1.4.0/24 

172.1.5.0/24 

172.1.6.0/24 

172.1.7.0/24 

E. 172.1.4.0/25 

172.1.4.128/25 

172.1.5.0/24 

172.1.6.0/24 

172.1.7.0/24 

Answer: C 


Q78. - (Topic 4) 

Refer to the exhibit. 

C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration? 

A. These commands need to be added to the configuration: 

C-router(config)# router eigrp 123 

C-router(config-router)# network 172.19.0.0 

B. These commands need to be added to the configuration: 

C-router(config)# router ospf 1 

C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0 

C. These commands need to be added to the configuration: 

C-router(config)# router rip 

C-router(config-router)# network 172.19.0.0 

D. No further routing configuration is required. 

Answer: D 


Q79. - (Topic 4) 

A Cisco router is booting and has just completed the POST process. It is now ready to find and load an IOS image. What function does the router perform next? 

A. It checks the configuration register. 

B. It attempts to boot from a TFTP server. 

C. It loads the first image file in flash memory. 

D. It inspects the configuration file in NVRAM for boot instructions. 

Answer: A 


Q80. - (Topic 4) 

A network administrator needs to allow only one Telnet connection to a router. For anyone viewing the configuration and issuing the show run command, the password for Telnet access should be encrypted. Which set of commands will accomplish this task? 

A. service password-encryption 

access-list 1 permit 192.168.1.0 0.0.0.255 

line vty 0 4 

login 

password cisco 

access-class 1 

B. enable password secret 

line vty 0 

login 

password cisco 

C. service password-encryption 

line vty 1 

login 

password cisco 

D. service password-encryption 

line vty 0 4 

login 

password cisco 

Answer: C