Top Quality 200-301 Faq 2021

NEW QUESTION 1
Refer to the exhibit.

What is the effect of this configuration?

• A. The switch port interface trust state becomes untrusted
• B. The switch port remains administratively down until the interface is connected to another switch
• C. Dynamic ARP inspection is disabled because the ARP ACL is missing
• D. The switch port remains down until it is configured to trust or untrust incoming packets

Answer: A

NEW QUESTION 2
Refer to the exhibit.

If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10.13.0.1 120 command how does the router respond?

• A. It ignores the new static route until the existing OSPF default route is removed
• B. It immediately replaces the existing OSPF route in the routing table with the newly configured static route
• C. It starts load-balancing traffic between the two default routes
• D. It starts sending traffic without a specific matching entry in the routing table to GigabitEthernetO/1

Answer: D

NEW QUESTION 3
Which two tasks must be performed to configure NTP to a trusted server in client mode on a single network device? (Choose two)

• A. Enable NTP authentication.
• B. Verify the time zone.
• C. Disable NTP broadcasts
• D. Specify the IP address of the NTP server
• E. Set the NTP server private key

Answer: DE

NEW QUESTION 4
How do TCP and UDP differ in the way that they establish a connection between two endpoints?

• A. TCP uses synchronization packets, and UDP uses acknowledgment packets.
• B. UDP uses SYN, SYN ACK and FIN bits in the frame header while TCP uses SYN, SYN ACK and ACK bits
• C. UDP provides reliable message transfer and TCP is a connectionless protocol
• D. TCP uses the three-way handshake and UDP does not guarantee message delivery

Answer: D

NEW QUESTION 5
Which result occurs when PortFast is enabled on an interface that is connected to another switch?

• A. Spanning tree may fail to detect a switching loop in the network that causes broadcast storms
• B. VTP is allowed to propagate VLAN configuration information from switch to switch automatically.
• C. Root port choice and spanning tree recalculation are accelerated when a switch link goes down
• D. After spanning tree converges PortFast shuts down any port that receives BPDUs.

Answer: A

NEW QUESTION 6
An email user has been lured into clicking a link in an email sent by their company's security organization. The webpage that opens reports that it was safe but the link could have contained malicious code. Which type of security program is in place?

• A. Physical access control
• B. Social engineering attack
• C. brute force attack
• D. user awareness

Answer: B

NEW QUESTION 7
A user configured OSPF and advertised the Gigabit Ethernet interface in OSPF By default, which type of OSPF network does this interface belong to?

• A. point-to-multipoint
• B. point-to-point
• C. broadcast
• D. nonbroadcast

Answer: B

NEW QUESTION 8
Drag and drop the WLAN components from the left onto the correct descriptions on the right.

• A. Mastered
• B. Not Mastered

Answer: A

Explanation:
5:1
1:2
2:4
4:3
3:5

NEW QUESTION 9
What is the primary effect of the spanning-tree portfast command?

• A. it enables BPDU messages
• B. It minimizes spanning-tree convergence time
• C. It immediately puts the port into the forwarding state when the switch is reloaded
• D. It immediately enables the port in the listening state

Answer: A

NEW QUESTION 10
How does HSRP provide first hop redundancy?

• A. It load-balances traffic by assigning the same metric value to more than one route to the same destination m the IP routing table.
• B. It load-balances Layer 2 traffic along the path by flooding traffic out all interfaces configured with the same VLAN.
• C. It forwards multiple packets to the same destination over different routed links n the data path
• D. It uses a shared virtual IMC and a virtual IP address to a group of routers that serve as the default gateway for hosts on a LAN

Answer: C

NEW QUESTION 11
Which configuration is needed to generate an RSA key for SSH on a router?

• A. Configure the version of SSH
• B. Configure VTY access.
• C. Create a user with a password.
• D. Assign a DNS domain name

Answer: B

NEW QUESTION 12
When configuring a WLAN with WPA2 PSK in the Cisco Wireless LAN Controller GUI, which two formats are available to select? (Choose two)

• A. ASCII
• B. base64
• C. binary
• D. decimal
• E. hexadecimal

Answer: AE

NEW QUESTION 13
Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?

• A. on
• B. auto
• C. active
• D. desirable

Answer: D

NEW QUESTION 14
If a notice-level messaging is sent to a syslog server, which event has occurred?

• A. A network device has restarted
• B. An ARP inspection has failed
• C. A routing instance has flapped
• D. A debug operation is running

Answer: A

NEW QUESTION 15
An engineer must configure a WLAN using the strongest encryption type for WPA2- PSK. Which cipher fulfills the configuration requirement?

• A. WEP
• B. RC4
• C. AES
• D. TKIP

Answer: D

NEW QUESTION 16
Refer to the Exhibit.

After the switch configuration the ping test fails between PC A and PC B Based on the output for switch 1. which error must be corrected?

• A. There is a native VLAN mismatch
• B. Access mode is configured on the switch ports.
• C. The PCs are m the incorrect VLAN
• D. All VLANs are not enabled on the trunk

Answer: A

NEW QUESTION 17
Which two actions influence the EIGRP route selection process? (Choose two)

• A. The router calculates the reported distance by multiplying the delay on the exiting Interface by 256.
• B. The router calculates the best backup path to the destination route and assigns it as the feasible successor.
• C. The router calculates the feasible distance of all paths to the destination route
• D. The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link
• E. The router must use the advertised distance as the metric for any given route

Answer: AD

NEW QUESTION 18
Which statement about Link Aggregation when implemented on a Cisco Wireless LAN Controller is true?

• A. To pass client traffic two or more ports must be configured.
• B. The EtherChannel must be configured in "mode active"
• C. When enabled the WLC bandwidth drops to 500 Mbps
• D. One functional physical port is needed to pass client traffic

Answer: C

NEW QUESTION 19
A frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented? (Choose two)

• A. runts
• B. giants
• C. frame
• D. CRC
• E. input errors

Answer: DE

NEW QUESTION 20
Which command prevents passwords from being stored in the configuration as plain text on a router or switch?

• A. enable secret
• B. service password-encryption
• C. username Cisco password encrypt
• D. enable password

Answer: B

NEW QUESTION 21
What is the primary different between AAA authentication and authorization?

• A. Authentication verifies a username and password, and authorization handles the communication between the authentication agent and the user database.
• B. Authentication identifies a user who is attempting to access a system, and authorization validates the users password
• C. Authentication identifies and verifies a user who is attempting to access a system, and authorization controls the tasks the user can perform.
• D. Authentication controls the system processes a user can access and authorization logs the activities the user initiates

Answer: C

NEW QUESTION 22
What is a benefit of using a Cisco Wireless LAN Controller?

• A. Central AP management requires more complex configurations
• B. Unique SSIDs cannot use the same authentication method
• C. It supports autonomous and lightweight APs
• D. It eliminates the need to configure each access point individually

Answer: D

NEW QUESTION 23
......