Exambible provide most current good quality 642-980 apply problems for that shoppers, we all promise business energy in the primary endeavor only with all of our quiz braindumps, in case in some way an individual fall short any Exambible 642-980 quiz in the first time, we wont solely organize the whole reimburse available for you. By ordering all of our Exambible 642-980 quiz in addition to 642-980, youll possess that is critical pertaining to doing the test with all of analysis direct that is always up-to-date.
2021 Mar 642-980 free practice test
Q41. Refer to the exhibit.
When suspending or deleting VSANs, which three statements are true? (Choose three.)
A. You can delete only one VSAN at a time.
B. You must wait 60 seconds after you enter the vsan suspend command before you enter another command.
C. You must wait 120 seconds after you enter the vsan suspend command before you enter another command.
D. You can unsuspend only one VSAN at a time.
E. You can delete multiple VSANs as long as they are in the same domain.
F. You can delete multiple VSANs as long as they are in the same zone.
Answer: ABD
Q42. The installation of a new OTV network connecting two data centers via a service provider LAN has failed verification steps. Which statement explains why certain types of data are not being successfully transferred across the OTV network?
A. The number of extended VLANs across all configured overlays may be greater than 256.
B. The number of MAC addresses on either edge device may exceed 4000.
C. The additional 42-byte OTV overhead, along with the DF bit being set, may cause the service provider to drop packets based on their 1500 MTU settings.
D. Having more than two edge devices per site is not supported.
Answer: C
Q43. One of your Cisco Nexus Series interfaces has become errdisabled with the error message "DCX-No ACK in 100 PDUs". How often are these acknowledgements exchanged?
A. 15 seconds
B. 30 seconds
C. 45 seconds
D. 60 seconds
Answer: B
Up to the minute 642-980 test preparation:
Q44. You have upgraded your Cisco Nexus 7009 Switches and converted the default VDC to an admin VDC. You notice that all of the ACLs are still present on the admin VDC after the conversion. What should you do?
A. enable configuration synchronization between the admin VDC and the production VDCs
B. delete the ACLs
C. delete all ACLs except those related to CoPP
D. delete all ACLs except those bound to resource templates
E. use the system admin-vdc acl command to properly migrate ACLs
Answer: B
Q45. You have enabled configuration synchronization between two Cisco Nexus 5548UP Switches. You create a port channel on switch 1 and determine that it was not synchronized with its peer. The peer switch can be pinged on the management VRF. When you check your peer status, you receive a "peer not reachable" message in the command output. What is the explanation for this?
A. CDP is disabled.
B. An LACP mismatch exists on the peer interfaces.
C. UDLD is disabled.
D. CFSoIP is disabled.
E. Multicast routing is enabled.
Answer: D
Q46. Which command displays the traffic statistics for a port channel interface?
A. show interface port-channel channel-number
B. show port-channel traffic
C. show port-channel usage
D. show port-channel compatibility-parameters
Answer: B