we provide Precise Cisco 200 355 dumps testing engine which are the best for clearing 200 355 dumps test, and to get certified by Cisco Implementing Cisco Wireless Network Fundamentals. The 200 355 wifund Questions & Answers covers all the knowledge points of the real cisco 200 355 exam. Crack your Cisco 200 355 pdf Exam with latest dumps, guaranteed!


♥♥ 2021 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 200-355 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 200-355 Exam Dumps (PDF & VCE):
Available on: http://www.surepassexam.com/200-355-exam-dumps.html

Q11. The network administrator wants an access point to be able to find rogue APs and to support location-based services. Which AP mode meets this requirement while having the radios up and preventing client connections? 

A. monitor 

B. sniffer 

C. rogue-detection 

D. H-REAP 

Answer:


Q12. What is the difference between the IEEE, the WiFi Alliance, and the FCC, ETSI, and TELEC? 

A. The IEEE and FCC are responsible for the standards that apply to wireless networks. The WiFi Alliance, ETSI, and TELEC are the governmental agencies that regulate compliance with local standards. 

B. The IEEE is responsible for Layer 1 and Layer 2 protocols. The WiFi Alliance is responsible for interoperability testing. The FCC, ETSI, and TELEC are responsible for radio frequency and transmission power-level regulations and standards in the U.S., Europe, and Japan. 

C. The IEEE is responsible for Layer 1 and Layer 2 protocols. The FCC, ETSI, and TELEC are responsible for interoperability testing and compliance. The WiFi Alliance is responsible for radio frequency and transmission power-level regulations and standards on a global basis. 

D. The IEEE and FCC are responsible for the Layer 3 protocol support and frequency and power-level regulations in the United States. ETSI and TELEC are responsible for frequency and power-level regulations in Europe and Japan. The WiFi Alliance is responsible to interoperability testing. 

Answer:


Q13. What are two wireless configuration utilities for Apple Mac computers? (Choose two.) 

A. AirPort 

B. AirPort Extreme 

C. AirManager 

D. AirManager Supreme 

E. AirAssistant Ultimate 

Answer: A,B 


Q14. A customer cannot access the GUI on the Cisco 5508 Wireless Controller from the management interface due to network failure. Which interface can the customer use to access the WLC GUI until the network issues are resolved? 

A. virtual 

B. dynamic 

C. console port 

D. service port 

Answer:


Q15. An engineer wants to setup WPA2 Enterprise using EAP-TLS and a remote RADIUS server. What device(s) would the engineer specify the EAP type on? 

A. the supplicant and authentication server 

B. the supplicant and authenticator 

C. the authenticator and authentication server 

D. the supplicant only 

E. the authentication server only 

Answer:


Q16. Which calculation computes the EIRP of an antenna? 

A. EIRP = Tx power (dBm) + Antenna Gain (dBi) - Cable Loss (dB) 

B. EIRP= Cable Loss (dB)+ Antenna Gain (dBi) - Tx power (dBm) 

C. EIRP = Cable Loss (dB)+ Antenna Gain (dBi) / Tx power (dBm) 

D. EIRP = Tx power (dBm) + Antenna Gain (dBi) / Cable Loss (dB) 

E. EIRP = Antenna Gain (dBi) - Cable Loss (dB) * Tx power (dBm) 

F. EIRP = Tx power (dBm) * Antenna Gain (dBi) / Cable Loss (dB) 

Answer:


Q17. Refer to the exhibit. An engineer wants to setup a mobility anchor for the Guest WLAN, but does not see the Anchor IP address listed in the drop-down. What is the most likely cause of this problem? 

A. The mobility anchor is currently unreachable. 

B. The mobility anchor must also be included in the mobility group of the WLC. 

C. Layer 3 Security must be configured for Web Policy Authentication. 

D. The mobility anchor is attached to another WLAN. 

E. Layer 3 Security must be configured for Web Policy Passthrough. 

Answer:


Q18. Which statement best describes the ability of a wireless client to access and transmit a data frame to an AP? 

A. The client listens to the media until polled by the AP using PCF to send its data. 

B. The client listens to the media until a data frame is finished, at which time it transmits, unless a collision of data frames has occurred. 

C. The client uses random countdown timers to start the transmission of a data frame. 

D. The client listens to the media and countdown timers to start the transmission of a data frame. 

Answer:


Q19. Which two statements about the requirements to configure inter-controller roaming are true? (Choose two.) 

A. The same mobility domain names are configured across controllers. 

B. The same RF group names are configured across controllers. 

C. The same controller hardware version is configured across controllers. 

D. The same AP manager interface is configured across controllers. 

E. The same virtual interface is configured across controllers. 

F. The same controller software version is configured across controllers. 

Answer: A,E 


Q20. What tab contains access point configuration in the WCS? 

A. Controller > Access Points 

B. Configure > Access Points 

C. General > Configure > Access Points 

D. System > Configure > Access Points 

Answer: