Act now and download your Cisco ccnp 300 101 pdf test today! Do not waste time for the worthless Cisco ccnp route 300 101 tutorials. Download Most up-to-date Cisco ROUTE Implementing Cisco IP Routing exam with real questions and answers and begin to learn Cisco route 300 101 with a classic professional.


♥♥ 2021 NEW RECOMMEND ♥♥

Free VCE & PDF File for Cisco 300-101 Real Exam (Full Version!)

★ Pass on Your First TRY ★ 100% Money Back Guarantee ★ Realistic Practice Exam Questions

Free Instant Download NEW 300-101 Exam Dumps (PDF & VCE):
Available on: http://www.surepassexam.com/300-101-exam-dumps.html

P.S. Accurate 300-101 testing software are available on Google Drive, GET MORE: https://drive.google.com/open?id=1VVsMJd1T1ylej0aePOIREXo7V31c7pn0


New Cisco 300-101 Exam Dumps Collection (Question 7 - Question 16)

Q1. Refer to Exhibit.

A network engineer is unable to make VRF lite EIGRP adjacency work. There is nothing wrong with communication between R1 and R2. What command will eliminate the issue when executed on both routers?

A. (config-router-af)#autonomous-system 100

B. (config)#ip-multicast-routing

C. (config-vrf)#route-target both 100:1

D. config-router-af)#network 209.165.202.128.0.0.0.31

Answer: A


Q2. An EUI-64 bit address is formed by adding a reserved 16-bit value in which position of the Mac address?

A. between the vendor OID and the NIC-specific part of the MAC address.

B. after the NIC-specific part of the MAC address.

C. before the vendor OID part of the MAC address.

D. anywhere in the Mac address, because the value that is added is reserved.

Answer: A


Q3. Which two options are components of a dual stack? (Choose two)

A. EIGRP

B. OSPF

C. IPv6 traffic

D. IPv4 traffic

E. Layer 3 switch

F. Layer 2 switch

Answer: C,D


Q4. Refer to the exhibit.

Based on this FIB table, which statement is correct?

A. There is no default gateway.

B. The IP address of the router on FastEthernet is 209.168.201.1.

C. The gateway of last resort is 192.168.201.1.

D. The router will listen for all multicast traffic.

Answer: C


Q5. Study this exhibit below carefully.

What is the effect of the distribute-list command in the R1 configuration?

A. R1 will permit only the 10.0.0.0/24 route in the R2 RIP updates

B. R1 will not filter any routes because there is no exact prefix match

C. R1 will filter the 10.1.0.0/24 and the 172.24.1.0/24 routes from the R2 RIP updates

D. R1 will filter only the 172.24.1.0/24 route from the R2 RIP updates

Answer: C

Explanation:

The command u201cdistribute-list 10 in Serial0 will create an incoming distribute list for interface serial 0 and refers to access list 10. So it will permit routing updates from 10.0.x.x network while other entries (in this case the 10.1.0.0/24 and 172.24.1.0/24 networks) will be filtered out from the routing update received on interface S0.


Q6. Refer to the following access list. access-list 100 permit ip any any log

After applying the access list on a Cisco router, the network engineer notices that the router CPU utilization has risen to 99 percent. What is the reason for this?

A. A packet that matches access-list with the "log" keyword is Cisco Express Forwarding switched.

B. A packet that matches access-list with the "log" keyword is fast switched.

C. A packet that matches access-list with the "log" keyword is process switched.

D. A large amount of IP traffic is being permitted on the router.

Answer: C


Q7. Which condition can cause unicast reverse path forwarding to fail?

A. split horizon

B. STP convergence

C. PortFast security violation

D. asymmetric routing

Answer: D


Q8. What are two limitations when in use of NPTv6 for IPV6 vs IPV6 Address translation?

A. stateful address translation

B. a limit of 32 1-to-1 translations

C. lack of overloading functionality

D. identify all interfaces NAT inside or outside

E. 1-to-1 prefix rewrite

F. mismatched prefix allocations

Answer: C,E


Q9. What are the three modes of Unicast Reverse Path Forwarding?

A. strict mode, loose mode, and VRF mode

B. strict mode, loose mode, and broadcast mode

C. strict mode, broadcast mode, and VRF mode

D. broadcast mode, loose mode, and VRF mode

Answer: A


Q10. A network engineer is configuring a routed interface to forward broadcasts of UDP 69, 53, and 49 to 172.20.14.225. Which command should be applied to the configuration to allow this?

A. router(config-if)#ip helper-address 172.20.14.225

B. router(config-if)#udp helper-address 172.20.14.225

C. router(config-if)#ip udp helper-address 172.20.14.225

D. router(config-if)#ip helper-address 172.20.14.225 69 53 49

Answer: A


Recommend!! Get the Accurate 300-101 dumps in VCE and PDF From Surepassexam, Welcome to download: https://www.surepassexam.com/300-101-exam-dumps.html (New 487 Q&As Version)